Ksd-110Lc Parts

This spacer provides a precise gap for proper alignment and clearance between components, helping maintain correct part positioning for reliable operation. It's a simple replacement that restores intended spacing and reduces wear. What it does:

• Positions and separates adjoining parts to maintain correct clearance
• Helps prevent rubbing, misalignment, or binding of moving components
• Restores factory spacing after maintenance or part replacement
• Fits where the original spacer was used to support assembly alignment

• One spacer as shown

• Inspect surrounding components and mounting surfaces for damage before installing
• Remove power to the appliance and follow manufacturer service instructions
• Install in the same orientation as the original spacer and verify proper clearance
• If fasteners or adjacent parts are worn, replace them to ensure a secure fit

This glass bracket secures the oven/microwave door glass, keeping the inner glass panel aligned and stable for safe operation. It replaces worn or damaged brackets to restore proper door fit and reduce rattling. What it does:

• Secures and supports the door's inner glass panel to maintain alignment
• Prevents glass movement that can cause vibration, noise, or improper sealing
• Helps restore proper door closing and even heat retention when functioning parts are present
• Commonly replaced when bracket is cracked, bent, or missing mounting integrity

• One glass bracket

• Disconnect power to the appliance before beginning any repair
• Handle glass carefully; wear cut-resistant gloves and eye protection
• Installation typically requires partial door disassembly and removal of retaining screws—keep track of fasteners

Color: White. Size: 1 qt. can. Acrylic appliance paint.

This surface burner igniter is the spark electrode that lights the flame on your gas cooktop or range. Replacing a worn electrode restores reliable ignition at the affected burner for fast, consistent lighting.

• Generates a high-voltage spark at the burner to ignite gas
• Positions and insulates the tip for consistent flame lighting
• Common symptoms: burner won't ignite or no spark at that burner
• Other signs: needs a match to light, intermittent/erratic spark, cracked ceramic

• Disconnect power and shut off gas supply; allow appliance to cool
• Remove burner cap and head to access the electrode; note wire routing and mounting
• Transfer any bracket/clip from the original part if required and set proper gap/position near the burner port
• Restore power and gas, then test ignition at the repaired burner

This is a standard oven rack that supports cookware and pans inside the oven, restoring a stable cooking surface for baking, roasting, and broiling. What it does

• Provides a durable shelf for pots, pans and baking sheets
• Slides into the oven's rack supports to position cookware at the correct cooking height
• Replaces bent, warped, or missing racks that cause uneven cooking or tipping
• Compatible with typical slide-in and drop-in rack support systems

• One oven rack

• Install by sliding the rack into the oven's existing rack supports until fully seated
• Make sure the rack is oriented correctly (top/bottom) per your oven's rack guides
• Always let the oven cool before removing or installing the rack and use oven mitts when handling hot racks
• Clean with non-abrasive cleaners; avoid steel wool or harsh chemicals that can damage the finish

This small mounting clip secures panels or components in place to help prevent rattles and movement during operation. It provides a simple, low-cost way to restore proper fit and reduce noise from loose parts. What it does:

• Holds trim, panels or wiring harnesses in position to prevent shifting
• Helps stop rattling or vibration caused by loose components
• Restores secure engagement where a broken or missing clip allowed gaps
• Commonly used where a small plastic or metal retainer is required to lock parts together

• One replacement clip as shown

• Turn off and unplug the appliance before starting any repair
• Inspect the mounting area to confirm clip orientation before installing
• Push or snap the clip into place; use hand tools only if needed to avoid damage
• Replace any adjoining fasteners or retainers that are worn