Ksm50pwh Parts

A replacement trim panel that restores the appliance's exterior finish and protects internal components from dust and debris. Helps maintain a clean look and keeps internal parts shielded after repair. What it does

• Acts as the exterior trim/cover over the appliance opening, preventing debris and lint from entering internal areas
• Protects switches, controls and internal wiring from accidental contact and damage
• Restores proper fit and finish when the original cover is cracked, warped or missing
• Stops rattling or gaps caused by a broken or loose cover

• Only install with power disconnected to avoid electrical shock
• Requires removal of adjacent panels or fasteners for access; use appropriate hand tools
• Handle carefully to avoid scratching the finish; align tabs and fasteners before tightening
• If fasteners or clips are damaged, replace them to ensure secure fit

This seal is a flexible gasket designed to create a tight, protective barrier between the appliance door and cabinet, helping prevent leaks and maintain proper operation. It replaces worn or damaged seals for a reliable closure. What it does:

• Forms a watertight/airtight seal around the door or opening to help prevent leaks
• Keeps heat or moisture inside the appliance for efficient performance
• Reduces drafts, vibration noise, and movement at the door edge
• Worn, torn, flattened, or missing seals can cause leaks, poor operation, or visible gaps

• One replacement seal

• Disconnect power and water before starting any repair
• Inspect mounting channel and hardware; some installs require door or trim removal
• Use manufacturer-recommended tools and avoid stretching the seal excessively
• If adhesive or retainers are used, replace or service them as directed by OEM instructions

This replacement power cord provides the electrical connection needed for compatible Whirlpool appliances, restoring reliable power and safe operation. Use it to replace a damaged or worn cord that prevents the appliance from powering up. What it does:

• Delivers mains power from the outlet to the appliance so it can run normally
• Replaces frayed, cut, or heat-damaged wiring that can cause intermittent power or no power
• Helps eliminate loose or corroded connector issues that create arcing or unreliable connections
• Restores a secure, insulated pathway to reduce risk of shorts or electrical faults

• Disconnect power at the breaker or unplug the appliance before starting any work
• Tighten terminal connections securely and route the cord to avoid pinch points or heat sources

This cabinet base is the lower support panel that mounts under the appliance to protect internal components and help stabilize the unit. It provides a finished look while covering hookups and wiring at the bottom. What it does:

• Covers and protects the appliance's lower components from debris and accidental contact.
• Helps stabilize the appliance and maintain proper alignment with the floor.
• Prevents direct access to wiring, vents, or drains located at the base.
• Visible signs it's needed: cracked, dented, missing, or loose cabinet base; bottom panel gaps exposing components.

• One cabinet base panel.

• Disconnect power (and water, if applicable) before beginning any work.
• Use two people for removal/installation to avoid damage and injury.
• Remove any kickplate or access panels, then unfasten mounting screws and retainers.
• Align base, secure fasteners, and ensure appliance sits level before returning to service.

This gearcase housing is the molded enclosure that supports and protects the motor drive gears, keeping them aligned for reliable rotation. It restores proper gear engagement and prevents debris from entering the drive area. What it does:

• Houses and positions the motor drive gears so the drive system turns smoothly
• Protects internal gears from lint, dust, and moisture that can cause wear or jamming
• Helps maintain correct gear alignment to reduce noise, grinding, or slipping during operation
• Supports the motor/gear assembly for consistent power transfer to the drivetrain

• Install with original fasteners and proper torque to maintain alignment
• Inspect gears, seals, and nearby components; replace any worn parts while housing is accessible
• Disconnect power and follow manufacturer safety procedures before attempting service