Kui15 Parts

Protective edge guard grommet for ice maker cabinet panels. Cushions and protects panel edges from wear, chafing, and vibration. Replace if cracked or missing.

Edge guard grommet for ice makers. Protects edges and panels from sharp metal contact. Replace if cracked, worn, missing, or damaged to restore fit.

Top panel gasket seals the ice maker's upper compartment to maintain proper temperature and prevent air leaks. Replace if torn, cracked, or loose.

Mounting bracket for ice makers. Secures internal components in place. Replace if bracket is bent, cracked, broken, or missing to restore proper fit.

Cover grid for freestanding ice makers. Installs over the evaporator grid assembly. Replace if cracked, broken, or missing to restore proper appearance.

Bottom door hinge for ice makers. Secures lower door section for smooth opening and reliable alignment. Replace if door sags or won't close properly.

Ice maker door won't close properly or alignment is off? This top hinge restores secure mounting and smooth operation. Simple DIY fix in under 30 minutes.

Door stop for freestanding ice makers. Prevents door from overextending and controls opening range. Replace if broken, cracked, or missing to secure door.

Door stop for freestanding ice makers. Prevents door from overextending and controls opening angle. Replace if broken, cracked, or missing.

Replacement door cam for freestanding ice makers. This plastic cam component controls door operation. Order a new one if your original is cracked or broken.

Replacement door wrap for ice makers. This outer panel covers and protects the door assembly. Order a new wrap if yours is cracked, dented, or damaged.

Filler end cap for 15-inch ice makers. Replaces cracked, broken, or missing black end cap trim pieces. Installs at cabinet edge for finished look.

Tool accessory for ice makers. Used during installation, maintenance, or repair procedures. Replace if lost, damaged, or worn to ensure proper service work.

This electronic control board manages oven functions and the user interface so touchpad commands, timers, and display feedback work correctly. Replacing a failed board restores control communication and normal cycle operation. What it does:

• Receives input from the touchpad/controls and sends signals to the oven's relays and timers
• Manages displays, clock, and programmed bake/clean cycles
• Can cause unresponsive controls, blank or garbled display, or failure to start if it fails
• Works with the appliance's wiring harness and mounting bracket to integrate into the console assembly

• Disconnect power to the appliance before servicing to avoid electric shock
• Handle the board by its edges and avoid static discharge; disconnect wiring harnesses gently
• Verify connector orientation and seating during reassembly; secure with original mounting hardware
• After installation, restore power and run a basic cycle to confirm normal operation

Black plastic end cap that covers the door edge on freestanding ice makers. Replace if cracked, broken, or missing to restore proper door appearance.