Kuid308hps Parts

This screw grommet anchors a screw in thin appliance panels so trim, covers, or consoles stay tight. It provides a snug, vibration-damping fit where a standard screw could loosen or strip over time.

• Creates a captive insert so a screw can securely fasten to sheet metal or plastic panels
• Replaces a worn, cracked, or missing grommet to restore proper screw retention
• Helps reduce panel rattles and movement from vibration
• Typical signs of failure: screw won't tighten, panel or trim feels loose, grommet falls out

• Disconnect power and shut off gas/water as applicable before servicing
• Remove the screw and lift out the old grommet; clear debris from the opening
• Press the new grommet straight into the hole until fully seated and flush
• Reinstall the screw and tighten gently to avoid deforming the grommet

Refrigerator running loud or not cooling well? A worn condenser fan blade reduces airflow across the coil. This DIY fix takes 15-30 minutes.

The Reservoir Drain Tube is an OEM part for Whirlpool freestanding icemakers. It is responsible for draining melted water from the reservoir during the harvest cycle. This tube removes water to allow for new ice formation. 

Causes of a bad reservoir drain tube can include mineral buildup or blockages within the tube inhibiting proper drainage over time. Additional causes may be cracks, cracks, kinks, or other damage limiting water flow.

Symptoms of a bad reservoir drain tube include:

• Water not draining from the reservoir after harvest
• Excess water collecting in the reservoir 
• Slow or reduced ice production due to poor drainage
• Leaks or water spills around the drain tube area

This OEM Whirlpool replacement tube is also compatible with freestanding ice components manufactured by select Kenmore models. 

Ice maker not producing ice or pump not running? This pump wiring harness restores electrical connection to your ice maker pump for reliable operation.

Ice maker not producing ice or evaporator pan bulging? This evaporator requires HVAC certification, vacuum pump, gauges, and refrigerant skills.

Leaking or damaged tube in your ice maker? This replacement tube restores secure connections between components to prevent leaks and ensure proper flow.

Size: 8-18 x 1/2 inch.

Size: 8 x 1-1/4 inch.

This adjustable leveling leg threads into the appliance base to set height and stabilize the cabinet. Replacing a worn or missing leg helps stop rocking and vibration and helps maintain proper alignment for reliable operation.

• Provides adjustable support at one corner of the appliance
• Helps level the unit for correct alignment with floor or cabinetry
• Reduces rocking, vibration, and rattling noises
• Replaces stripped, bent, cracked, or missing leg

• Disconnect power and, if applicable, shut off water before servicing
• Carefully support or brace the appliance to access the base safely
• Start the new leg by hand to avoid cross-threading; adjust height gradually
• Use a level to check side-to-side and front-to-back, then recheck after positioning

Ice maker not filling or dispensing ice? A faulty solenoid valve coil prevents proper water flow. This coil restores reliable valve operation in your unit.

Drier tube for refrigerators. Installs in the sealed refrigeration system to remove moisture. Replace if cracked, corroded, or during compressor repairs.

Refrigerator not turning on or component not responding? This switch assembly restores electrical control to activate functions correctly. Direct replacement.

Holds and secures the water filter in your ice maker, ensuring clean filtered water. Replace if cracked, leaking, or filter won't seal properly. Verify fit with your model number before ordering.

Size: 8-18 x 5/8 inch.

Replace your ice maker's door gasket to restore the seal around the door, prevent air leaks, and maintain proper temperature. Confirm fit with your model number.

No water or ice? A cracked or clogged water tube can stop flow to your ice maker. This tube directs water from the valve to restore reliable ice production.