We use cookies and similar tools for site analytics and advertising. By using our site, you agree to this. See our Privacy Policy for details. Do Not Sell or Share My Personal Information
Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Used the tool i purchased to remove stubborn brake assembly it worked great Read more
Lower brake bearing
I first replaced the two drive belts and the motor springs. That didn't fix it although they did need replacing. I then replaced the two bearings and the brake assy. The washer runs like new. If you replace the brake assembly, you should also replace the bearings. It will save a tear down later on. The Maytag repairman wanted $600.00 dollars to do the job. I did it for less than $200.00. Read more
Perfectly! Replacing Agitator Shaft is not for the faint of heart. Replacing output shaft pinion gear on the bottom of the agitator shaft requires care, experience and patience with pressing/driving drift pins without damaging the gear itself. One slip of the drift/punch or press apparatus will ruin the gear/teeth face and will lead to failure of the transmission internally when put back into service. As best as I can tell the pinion gear is discontinued and no longer available so take care!... Read more
Using your video then calling Tina, who researched a part I had that wasn't in video or parts list. She had me send in a picture and researched then called me back. The part was redesigned. She was very helpful. Read more
This inlet fitting allows bleach to enter the washer's dispenser system and connects to the main water supply line. Replace when bleach doesn't dispense properly, leaks occur around the inlet, or the fitting becomes clogged or damaged.
Amazed that the part was still made. The old part just fell apart. Be sure to keep the gasket Vynl is still good. YOu have to force the part in along the gasket Read more
Washer shaking or stopping mid-spin? This unbalance plunger detects off-center loads to maintain proper spin speed. Direct replacement part.
Before I took it apart I thought it had a broken tub tensioner spring. After some research, I thought it might be worn damper pads. Upon disassembly I found the springs and pads intact, pretty amazing for a 25 year old machine. All I did was re-lubricate the pads and put everything back together and give the spring adjusters a half a turn more tension. Test ran two loads and it ran perfect. As a side note, the springs that came and were supposed to be for my machine were too short, smaller... Read more
Rebuilding my 30 year old Maytag Washer, and my 35 year old Kenmore dryer. All the new products seem to be a nightmare. Read more
This decorative ring surrounds the timer dial and provides a finished appearance to the washer control panel. Located around the timer knob on the front panel, it should be replaced when cracked, discolored, or no longer fits securely in place.