Lat90356aae Parts

Ordered all 3 parts for thr timer and replaced originals. Read more

Ordered my replacement unit from APP, along with a few other "while I am fixing this I should replace that since I am disassembling the washer" parts also from APP. After 2 hours of repair work, the washer is back in full working as new order. The only recommendation to others is make sure you order ALL the parts for the job. Take time to investigate all that you will or might need to replace. An ounce of prevention is worth the pound of cure. Like the old line; measure twice and cut... Read more

Used the tool i purchased to remove stubborn brake assembly it worked great Read more

I first replaced the two drive belts and the motor springs. That didn't fix it although they did need replacing. I then replaced the two bearings and the brake assy. The washer runs like new. If you replace the brake assembly, you should also replace the bearings. It will save a tear down later on. The Maytag repairman wanted $600.00 dollars to do the job. I did it for less than $200.00. Read more

I installed a new timer Read more

I ordered a pressure switch and a pressure hose. It just took a few minutes. Read more

Replaced the pressure switch. Simple fix. Read more

• Leaking

Perfectly! Replacing Agitator Shaft is not for the faint of heart. Replacing output shaft pinion gear on the bottom of the agitator shaft requires care, experience and patience with pressing/driving drift pins without damaging the gear itself. One slip of the drift/punch or press apparatus will ruin the gear/teeth face and will lead to failure of the transmission internally when put back into service. As best as I can tell the pinion gear is discontinued and no longer available so take care!... Read more

Using your video then calling Tina, who researched a part I had that wasn't in video or parts list. She had me send in a picture and researched then called me back. The part was redesigned. She was very helpful. Read more

Amazed that the part was still made. The old part just fell apart. Be sure to keep the gasket Vynl is still good. YOu have to force the part in along the gasket Read more

Before I took it apart I thought it had a broken tub tensioner spring. After some research, I thought it might be worn damper pads. Upon disassembly I found the springs and pads intact, pretty amazing for a 25 year old machine. All I did was re-lubricate the pads and put everything back together and give the spring adjusters a half a turn more tension. Test ran two loads and it ran perfect. As a side note, the springs that came and were supposed to be for my machine were too short, smaller... Read more

With talent on loan from god. Read more