Lc-248J Parts

Red adhesive strip for washers. Secures components and panels inside the cabinet. Replace if peeling, missing, or no longer holding parts in place.

A small threaded fastener used to secure components to shafts or hold assemblies together. This set screw restores proper fit and helps stop slipping, rattles, or misalignment caused by a loose fastener. What it does:

• Secures pulleys, collars, knobs, or other components to a shaft to prevent movement
• Stops slipping and eliminates related noise or vibration when tightened properly
• Maintains alignment of moving parts to preserve smooth operation
• Simple replacement for applications where the original set screw is worn or missing

• One set screw

• Disconnect power to the appliance before starting any repair
• Use the correct driver or hex key to avoid rounding the head
• Tighten until snug; avoid overtightening which can strip threads or break the screw
• If the screw fastens a rotating part, test operation at low speed after installation

This spacer positions and supports appliance components to keep parts aligned and prevent rubbing or misfit during operation. It's a small replacement piece that restores correct clearances and helps eliminate noise or wear from loose assemblies. What it does:

• Provides a stable gap or standoff between mating parts to ensure proper alignment
• Prevents panels, brackets, or moving parts from rubbing or contacting each other
• Helps reduce vibration-related noise and uneven wear caused by misaligned components
• Commonly replaced when cracked, deformed, or missing after service or impact

• Disconnect power and water before servicing the appliance
• Verify the spacer orientation and seating against mating surfaces before tightening fasteners
• Use basic hand tools; avoid forcing parts to prevent breakage
• If multiple spacers are present, replace all damaged pieces to maintain proper alignment

This resistor for the fabric selector switch controls the dryer's moisture/dryness sensing circuit so the dryer can select the correct heat level for different fabric types. It helps restore proper selector function for consistent drying results. What it does:

• Provides the correct resistance values to the fabric selector so the dryer chooses appropriate heat for cotton, permanent press, delicate settings
• Restores selector responsiveness when a worn resistor causes incorrect or no heat selection
• Works as part of the dryer control circuit that affects cycle dryness and temperature regulation
• Replaces a damaged or open resistor causing intermittent or failed selector operation

• Resistor for fabric selector switch

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Access may require removing the dryer control panel or console—keep screws and fasteners organized
• Handle the resistor and wiring gently; avoid bending contacts or pulling on wires