Ldg4313 Parts

Idle packing bushing for electric and gas ranges. Replaces worn, cracked, or missing bushings. Ensures proper fit and cushioning for range components.

This is the orifice holder that sits beneath the surface burner on a gas range, securing the gas orifice in position so fuel is directed properly to the burner head. It ensures a consistent and correctly shaped flame for even cooking. Replace this part if you notice irregular flame patterns, difficulty igniting a burner, or if the orifice is loose or misaligned.

Secures the gas burner nozzle in your range cooktop. Replace this holder if it's cracked, broken, or no longer holding the nozzle firmly in position.

Gas burner won't light or won't turn off? This gas range valve controls gas flow to burners. Moderate DIY repair taking 30-45 minutes with basic tools.

This insulator is the mica sheet that covers the microwave's waveguide opening. It shields the cavity from food splatter and moisture while allowing microwave energy to pass, helping prevent arcing and protecting internal components.

• Covers the waveguide port to keep grease and debris out
• Helps prevent sparking/arcing inside the cavity
• Restores safe, even microwave operation when the original is burned or stained
• Typical symptoms: visible burn marks or charring on the cover, arcing/sparking during use, unusual noises

• Unplug the appliance before service; high-voltage components can retain charge
• Remove the old cover by releasing mounting screw or tabs; clean residue from the area
• Do not bend or crack the new mica; install with the same orientation
• If trimming is required per service literature, follow the outline of the original cover only

This hardware washer helps distribute fastener load and maintain proper spacing in your LG appliance. Replacing a missing or worn washer restores secure mounting and alignment, reducing vibration and rattling from loose assemblies.

• Distributes the load of a screw or bolt and protects mating surfaces to maintain alignment
• Helps keep components secure and at the correct spacing
• A damaged or missing washer can lead to loosening, vibration, or rattling during operation
• Ensures correct hardware stack-up during reassembly after service

• Disconnect power and shut off water or gas before servicing
• Note the order and orientation of any washers/spacers; take a reference photo
• Use the correct driver or wrench and tighten snugly—do not overtighten
• Replace companion hardware if corroded, stripped, or damaged

Fixes weak or uneven flames on gas range burners. This nozzle meters fuel flow to each burner for balanced heating. Direct replacement part.

Replace your range control panel if buttons aren't responding or the display is blank. This electronic user interface restores touchpad function and cycle selection.

If your gas range burner won't ignite or heat unevenly, this surface burner assembly restores reliable flame and even cooking. Moderate DIY repair.

Replaces damaged or missing Poise cover on your range. Restores exterior protection and finished appearance while shielding internal components.

Fix burners or oven not lighting with this gas valve assembly. Controls gas flow to restore safe ignition and consistent heating in your range.

Fixes intermittent power or control issues caused by damaged wiring. This harness restores electrical connections between range components for reliable operation.

This heater cover is the replacement housing that protects the dryer heater assembly and helps direct airflow for reliable drying performance. It restores proper heater positioning and helps prevent contact with heating components. What it does:

• Protects the heater assembly and surrounding components from debris and direct contact
• Helps channel airflow through the heater area for consistent drying
• Can reduce rattling or noise caused by a damaged or loose heater cover
• May be replaced when cover is cracked, warped, or missing fasteners

• Disconnect power (unplug or shut off breaker) before servicing to avoid shock or injury
• Inspect mounting tabs and fasteners; replace any damaged clips or screws for secure fit
• Minor disassembly of the dryer cabinet may be required; keep track of removed screws and panels
• If you smell burning or see damaged wiring, stop.