Lesa907pbl02 Parts

This mechanical refrigerator thermostat regulates interior temperature, letting the compressor cycle on and off to maintain your set cooling level. It's a direct replacement for worn or unresponsive temperature controls to restore consistent cooling. What it does:

• Senses cabinet temperature and signals the compressor to run or stop to maintain setpoint
• Replaces a thermostat that won't hold temperature, causes continuous running, or prevents cooling
• Works with manual temperature-control knobs (mechanical sensing and switching)
• Typical failure symptoms: refrigerator too warm, too cold, or compressor that runs constantly or not at all

• Disconnect power before attempting any service to avoid shock or damage
• Access may require removing control panels or shelves; keep track of mounting screws and orientation
• Confirm wiring and terminal placement match the old thermostat before final connection

The Wiring Harness is an OEM part for SpeedQueen dryers. The wiring harness is a network of wires that connect the dryer's electrical components, such as the temperature sensor, door switch, drum motor, and heating element. It allows these components to communicate and function together as the dryer operates.

Causes of a bad wiring harness can be wear and tear over time, cuts or abrasions to the wires from repeated movement in the dryer cavity, or wire fatigue from constant electrical current.

Symptoms of a bad wiring harness include:

• Intermittent or unreliable operation
• Certain components not functioning properly
• Error codes displaying or cycles ending prematurely
• Loose, damaged, or cracked wires

This 1/4" female spade terminal provides a secure electrical connection for appliance wiring, restoring reliable contact between wires and male tabs. It's a simple replacement for worn, loose, or corroded quick-disconnect fittings. What it does:

• Creates a reliable, removable electrical connection to 1/4" male tabs
• Prevents intermittent power or signal loss from loose or damaged connectors
• Helps reduce arcing or overheating at a poor connection point
• Compatible with standard insulated or non-insulated wire terminations

• Disconnect power before inspecting or replacing any wiring or terminals
• Use the correct crimping tool or solder per the appliance manufacturer's recommendation
• Match terminal style (insulated vs. non-insulated) and wire gauge to the original part
• Inspect mating male tab and wiring for corrosion or damage; replace if needed

This female piggyback terminal is a quick-disconnect electrical connector designed to join or extend wire connections safely, letting a second male tab piggyback on an existing spade connection for easy component hookups. What it does:

• Provides a secure female quick-disconnect that accepts a male spade and allows a second male tab to be connected on top (piggyback).
• Used where an additional circuit or component needs to tap into an existing spade connection.
• Commonly replaces worn, corroded, or loose spade/terminal connections that cause intermittent power or component failure.
• Helps restore reliable electrical contact and reduces arcing from poor terminals.

• Disconnect power to the appliance before inspecting or replacing terminals to avoid shock or damage.
• Crimp or solder per OEM guidance and use appropriate insulation or heat-shrink if required.
• Replace damaged wiring or terminals; secure harnesses to prevent strain on the new connector.