Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Upper hinge assembly for refrigerator doors. Mounts at the top to support and pivot the door. Replace if hinge is worn, cracked, or broken to restore alignment.
Ordered gasket and hinges. Hired an appliance repair contractor to change out the old ones. It's fine now. Read more
Refrigerator not dispensing water or making ice without a filter? This bypass cap lets water flow directly to the dispenser and ice maker. Easy install.
Installed the bypass Read more
Refrigerator not cooling or blowing warm air? This compressor assembly restores proper cooling. Advanced repair requiring EPA certification for refrigerant.
Reduce refrigerator rattling and humming from the compressor area. This damper absorbs vibration between the compressor and base for quieter operation.
Exterior emblem nameplate that mounts to your refrigerator's front panel. Replaces missing, cracked, or faded badges to restore a clean look.
The old filter head was broken at the supply line side connector fell out. The clicking noise eventually caused the fridge to warm up and stop cooling. The clicking was the overload relay tripping. The Start solenoid on the compressor was an Embarco TSD part 513604044. APP does not have that part nor does any else found a similar one on ebay but I ordered the PTC assembly 6749C-0014E. I removed the overload relay and capacitor from the TSD used two pieces of wire and connectors to create the... Read more
Refrigerator won't start or stops running? A failed capacitor disrupts motor circuits. This film radial capacitor restores voltage stability and operation.
For an emergency fix I installed a 3 in1 kit disabling the original start cap and wiring in the original run cap to the run winding. Ordered the proper PTC and overload from Appliance Parts Pros and installed them 2 weeks later. The original start and run capacitor were good, rewired back to design specs. The original PTC had pins 1,2 and 3, the replacement had 2,3 and 4. Only wiring change was to install the red wire from pin 1 on the original PTC to pin 4 on the new PTC. Read more
Molded protective housing that shields internal wiring and hoses from wear and debris. Replace if cracked, broken, or missing to maintain safe operation.
Replacement door stopper assembly that cushions and limits door travel. Installs at the hinge area. Needed when original is cracked, broken, or missing.
Holds the water filter and connects water lines in your refrigerator. Replace if leaking, cracked, or connections are damaged. Verify fit by model number.
Silver drip tray for side-by-side refrigerators. Replaces cracked, discolored, or missing trays. Measures 9.5 inches wide by 5 inches deep.
Replaced rubber cover Read more
Ice not dispensing or grinding noise from dispenser? This auger motor rotates the ice bin auger to move ice cubes through the chute. DIY repair part.
Seals refrigerator door to maintain temperature and efficiency. Replace when worn, torn, or causing air leaks and frost buildup. Verify fit with model number.
Removed old gasket & cleaned around door opening. Installed new gasket with no problem. Read more
Replace your refrigerator's cracked or discolored light lens cover to restore even illumination and protect the bulb from spills and impact. Confirm fit.
The lamp cover and freezer door gasket were simple to replace, however before doing the repairs I discovered that the water line to the ice maker was leaking therefore I got help from a repair person at a local appliance store to fix the line and he also helped with the installation of the ice chute door....I would say the most difficult part was getting to the old ice chute door to replace as you have to be careful that you don't break one of the tabs holding the dispenser unit in place, but... Read more
Defrost sensor that mounts to the evaporator coils in your refrigerator's freezer compartment. Replace if cracked, corroded, or showing error codes.
Replaced defrost sensor which is the controller assembly and error code gone Read more
Protective cover for your refrigerator's PTC and compressor start device assembly. Replace if cracked, melted, or missing to shield components from damage.
Replaced the start relay and overload. I had only a blue wire and black, no pink. I put the black wire on the relay terminal toward the insideof frig. The blue went on the overload. Read more
Replacement mounting screw for securing panels, brackets, and assembliance components. Needed when original screws are missing, stripped, or damaged.