Lsc23924st/01 Parts

The compressor overload protector is a safety device that prevents the refrigerator compressor from overheating by cutting power when temperatures exceed safe limits, located on or near the compressor. Replace when the refrigerator frequently stops cooling, the compressor clicks on and off rapidly, or the unit fails to start.

This drive motor powers the appliance's rotating drum or tub, restoring proper rotation so loads tumble or agitate as intended. Replaces a worn or failed motor to stop humming, no-rotation, or intermittent spinning problems. What it does

• Spins the drum/tub so laundry or items tumble and clean/dry evenly.
• Accepts the drive belt (where applicable) and transmits torque to rotate the load.
• Stops operation when internal thermal or electrical faults occur, which can cause humming or no-spin symptoms.
• Commonly replaced when the unit fails to start, stalls under load, or makes unusual noises.

• One drive motor (single motor assembly)

• Disconnect power before beginning any repair to avoid shock or injury.
• Access typically requires removing the cabinet or rear panel and supporting the drum/tub while unbolting the motor.
• Note belt routing and electrical connector positions during removal to ensure correct reassembly.

This ice bucket assembly collects and stores ice produced by the refrigerator's ice maker, restoring a secure, easy-to-access bin for ice storage and retrieval. Ideal when the original bucket is cracked, warped, or worn. What it does

• Holds and stores ice produced by the ice maker so ice stays contained and accessible.
• Guides ice into the bin to prevent spills and keep the freezer organized.
• Helps reduce ice jams or blockage caused by a cracked or misshapen bucket.
• Replaces damaged or discolored ice bins that no longer retain or dispense ice properly.

• Disconnect power to the refrigerator before starting any repair to avoid injury.
• Remove remaining ice and allow any frost buildup to melt before removing the old bucket.
• Handle the plastic bucket carefully to avoid cracking; reinstall using the factory clips/screws as shown in your service diagram.