Lt5000xvwo Parts

White control knob for washer control panel. Replaces cracked, broken, or missing knobs. Attaches to cycle selector or timer shaft on front panel.

White front panel for laundry center units. Replaces cracked, dented, or discolored exterior panels. Restores the clean appearance of your appliance.

This cove transition panel is the black trim piece that restores the look and fit between your cooktop and control area. It provides a finished appearance and replaces a cracked, bent, or missing transition trim. What it does:

• Covers the gap between the cooktop and control/cabinet area for a clean, finished appearance
• Replaces damaged, cracked, or warped trim that can affect panel alignment
• Helps maintain correct spacing and fit of adjacent trim pieces
• Restores original factory appearance after collision or wear

• Disconnect power to the appliance before starting any work
• Handle edges carefully to avoid cuts and prevent scratching the finish
• Minor disassembly of surrounding trim or panels may be required; keep fasteners organized

Size: 6 - 20 x 1 1/16 inch.

Washer won't agitate or makes grinding noises? This agitator shaft connects the agitator to the drive system. Moderate DIY repair, 30-45 minutes.

Secures panels and components in place. Replace this fastener if stripped, corroded, or missing to restore proper alignment and eliminate rattling.

Dryer drum baffle installs inside the drum to lift and tumble clothes evenly. Replace when cracked, broken, or missing to restore proper drum function.

Front drum bulkhead for your dryer. This structural component supports the drum assembly. Replace if cracked, broken, or worn to restore proper drum support.

Edge protector for laundry center units. Installs along cabinet or panel edges to cover sharp metal and prevent injury. Replace if cracked or missing.

Wire connector block for washers. Transfers electrical connections between wiring harnesses. Replace if connector housing is cracked or melted.

Washer won't stop spinning smoothly or makes loud jerking noise when stopping? The brake shoe stops the tub during spin cycles. DIY repair in 1-2 hours.

This 1-1/8 in wire retaining ring locks into a groove to secure components in place. It helps prevent parts from sliding off a shaft or shifting out of position so assemblies stay aligned and operate reliably.

• Holds components on a shaft or within a groove to prevent axial movement
• Maintains alignment of related parts in the assembly
• Common failure signs: ring is bent, missing, or won't stay seated
• Symptoms include loose or wobbly parts and rattling during operation

• Disconnect power before servicing
• Wear eye protection—retaining rings can spring free during removal
• Use appropriate snap-ring pliers or small picks to remove/install
• Ensure the ring is fully seated in the groove before reassembly and use

Leaking washer or water pooling near your laundry center? A cracked inlet hose is often the cause. This hose routes water from the valve to the drum.

This retainer clip secures a component in place to prevent movement and maintain proper alignment during appliance operation. Replacing a damaged or missing clip helps restore safe, reliable performance.

• Holds the mating part firmly to reduce vibration and noise
• Helps prevent intermittent operation caused by loose fitment
• Common fix when a component feels loose, rattles, or won't stay seated

• Disconnect power and shut off gas/water before servicing
• Note original clip orientation and location before removal
• Use needle-nose pliers to carefully release and install the clip
• Do not over-bend the clip; replace if deformed or fatigued