Ltg6234001 Parts

Replace worn, stripped, or missing 8-18 x 3/8 machine screws that secure control panels, trim pieces, and brackets on your appliance. Restores tight fit.

This siphon break kit prevents water from siphoning back out of the washing machine tub through the drain hose during the fill cycle. It acts as an air gap device installed on the drain line to ensure proper water levels are maintained. Replace this kit if your washer is not filling properly, takes too long to fill, or you notice water draining out as fast as it fills.

Right-side door hinge for laundry centers. Replaces worn or damaged pivot point to restore proper door alignment and prevent sagging or gaps in the seal.

Secures shafts and pulleys in your washer to prevent axial movement. Replace when worn or damaged to restore proper alignment. Confirm fit with model.

Factory dryer door hinge that supports and pivots the door for smooth opening and closing. Replace if twisted, bent, or worn to restore proper alignment.

Drain hose nozzle that attaches to the end of your washer's drain hose. Replace if cracked, broken, or missing to ensure proper hose connection.

This pressure switch is a replacement air-pressure sensor that helps the appliance detect proper airflow and system pressure so cycles run correctly and safety systems operate as intended. What it does

• Senses changes in air or system pressure and sends a signal to the control to advance or stop cycles
• Helps ensure proper venting and airflow for heating and drying functions
• Can cause long cycles, failure to start, lack of heat, or error codes when faulty
• Works with the appliance's vacuum hose/tubing and electrical connector to monitor pressure

• Disconnect power (and gas, if applicable) before beginning work
• Handle the vacuum hose and small fittings carefully to avoid cracks or leaks

Fix a washer drum that won't stop spinning or releases incorrectly. This brake spring restores proper tension to the brake assembly for normal operation.

10-16 x 1/2 inch screw secures panels, trim, and brackets on appliances. Replace missing, stripped, or damaged fasteners to restore secure fit.

Blower housing assembly that directs airflow from the drum to the exhaust vent. Replace if cracked, damaged, or causing excessive noise in your dryer.

The dryer grounding clip is a small metal fastener that maintains a secure electrical ground connection between components inside your dryer. A proper ground is essential for safe operation and helps protect against electrical shock or appliance damage. Replace this part if it is bent, corroded, or missing, especially if you are experiencing intermittent electrical issues or completing a repair that requires re-grounding internal parts.

Replacement locator for your laundry center. Installs to position and secure components in place. Order a new part if your original is broken, missing, or damaged.

Leaking water connection? This hose coupling creates a secure seal between your washer hose and water inlet, stopping drips and loose connections. DIY fix.

Connects the drain hose to the washer drain outlet. Replace this coupling kit if cracked, broken, or leaking to restore a secure connection.

Left-side door hinge for laundry center appliances. Restores proper door support and alignment. Replace if hinge is bent, cracked, or worn.

This is a flat steel washer with approximate dimensions of 28.65mm inner diameter, 39.6mm outer diameter, and 0.965mm thickness. It serves as a spacer or fastener component in various appliances, helping to distribute load and prevent loosening of bolted connections. Replace this washer if it is cracked, deformed, or corroded, which can cause rattling, loose fittings, or improper alignment of parts.