Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
This knob controls the rinse aid dispenser setting in your dishwasher, allowing you to adjust how much rinse aid is released during the wash cycle. It typically has numbered settings from low to high dispensing amounts. Replace it if you can't adjust the rinse aid flow, the knob is missing, or if it won't stay in the selected position.
Was easy to locate exact part needed by inputting model number Received my part in under a week. Great site for parts Read more
This factory fastener secures panels, brackets, or internal components in your appliance. Replacing a missing or damaged screw restores a tight fit, reduces rattles, and keeps assemblies properly aligned for dependable operation.
Replaced drawer Read more
This door hinge restores smooth, controlled door movement and a tight, secure close. Replace a bent or worn hinge to correct doors that sag, bind, or won't stay closed, helping your appliance seal properly and perform as designed.
What's included: 1 door hinge assembly Installation notes:
This replacement light lens covers and protects the appliance control panel light while diffusing illumination for clearer, less-glare visibility. Restores the control area's appearance and helps ensure even lighting across the panel. What it does:
What's included: One replacement light lens. Install notes:
Fix unresponsive dispenser buttons or stuck ice/water selection with a new control board. DIY-friendly repair takes about 10 minutes with basic tools.
Purcased pc board. Pull water tray out which exposeses two screws. Take them out lift up on cover. Remove wire harnes from pc board then remove two small screws from pc board. Put new board in and reverse process. Takes about ten min. Read more
This O-ring creates a watertight seal in your dishwasher's wash or drain system, helping prevent leaks and maintain proper water pressure. Replace a brittle, flattened, or damaged ring to restore a reliable, leak-free connection.
Removed 8 screws that retain inner door to outer door. Removed rinse aid dispenser nut and replaced O-ring around dispenser. Also, removed 2 screws that retain the latch assembly and replaced rubber grommet around latch lever that retains soap dispenser door. Read more
Twisted old clip out and new one in. Works little different then video. This clip doesn't work with wrench. Read more
The foam was shot on the detergent cup lid. Hard as a rock. Causing caking problems, dribble down the inside wall of the door and leaving lumps of detergent. Cut the door in half wit aviation snips and pulled out the two halves. Discovered at this point that the spring had gone soft. Bought one ahead of time, so I was set. Put the spring on the left pin, put the spring pin in the door, slipped the door into place (open) and put the right pin in with pliers. Door snaps open now. Read more
Note: Check Serial Number for correct part
I installed the door latch assembly and handle. It worked fine after that. Read more
Replacement screw for securing dishwasher door panels, inner liners, and internal brackets. Needed when original screws are stripped, missing, or damaged.
Ordered the part from AppliancePartsPro's, watched the video, new latch works perfect. I've repaired several appliances in my house by diagnosing simple problems going to AppliancePartsPro's diagram's, ordering the part and installing myself. Never had any problems. The bearing in the back of the dryer was tricky but worked great. Keep track of all parts when you disassemble and assemble in reverse order. Taking photos as you disassemble helps for referencing if you get stumped. Read more
Upper wash arm retaining clip.
I first attempted to order through Sears as the unit was purchased through Sears. Their parts system indicated the part I needed was NLA! I then Inquired at Appliance Part Pros and the less than $8 part was in stock. Parts arrived quickly and Washer is now back in service. Read more
Fix dishes not cleaning or low water pressure in your dishwasher. This nozzle jump up directs water to the spray arm. Easy 5-minute install, no tools needed.
I looked in the bottom of the dishwasher and saw that the center piece of the water wheel had somehow come loose. That center piece was lodged under the heating element and was now somewhat beaten and melted. We looked on line for an illustrated parts breakdown and found it on Appliance Parts Pros website. The diagram was so clear and straight forward that it was easy to see the part that we needed and another part (when we looked) we also found missing. Well, 3 days later the parts came in... Read more
Guides dishwasher rack for smooth sliding. Replace this track when cracked, bent, or worn to restore stable rack movement and prevent binding or sagging.
Ordered new frame, wheels and SS slide for the bad side. Job was done in 10 minutes and the rack now works smoothly. Read more