Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Usually ships within 4 - 14 days
This hold-down strap secures components in place to reduce movement and vibration, helping maintain stable operation and prolong part life. It's a simple replacement that restores proper fastening where the original strap has worn or failed. What it does:
This water level switch senses the dishwasher's tub float and controls the water inlet. Replacing a worn switch restores correct filling, helping prevent overfilling or dry cycles that can reduce cleaning performance. What it does:
What's included:
Install notes:
I called and talked to a customer service rep and she helped me troubleshoot the problem and order the correct part. She also sent me the pdf of the repair manual and I followed its instructions to replace the drain solenoid. It was a fairly easy repair. I wasn't sure if I would need the water level control switch, but I ordered it to be on the safe side. Turns out the original is still good. Read more
Was easy to locate exact part needed by inputting model number Received my part in under a week. Great site for parts Read more
The foam was shot on the detergent cup lid. Hard as a rock. Causing caking problems, dribble down the inside wall of the door and leaving lumps of detergent. Cut the door in half wit aviation snips and pulled out the two halves. Discovered at this point that the spring had gone soft. Bought one ahead of time, so I was set. Put the spring on the left pin, put the spring pin in the door, slipped the door into place (open) and put the right pin in with pliers. Door snaps open now. Read more
This O-ring creates a watertight seal in your dishwasher's wash or drain system, helping prevent leaks and maintain proper water pressure. Replace a brittle, flattened, or damaged ring to restore a reliable, leak-free connection.
Removed 8 screws that retain inner door to outer door. Removed rinse aid dispenser nut and replaced O-ring around dispenser. Also, removed 2 screws that retain the latch assembly and replaced rubber grommet around latch lever that retains soap dispenser door. Read more
Note: Check Serial Number for correct part
I installed the door latch assembly and handle. It worked fine after that. Read more
Upper wash arm retaining clip.
I first attempted to order through Sears as the unit was purchased through Sears. Their parts system indicated the part I needed was NLA! I then Inquired at Appliance Part Pros and the less than $8 part was in stock. Parts arrived quickly and Washer is now back in service. Read more
Replaced the water injector and seal. Read more
Ordered the new o-rings for the pump housing and main filter screen unit. Cleaned all water hardness and other debris out of all parts. Main filter and inside parts clogged with water hardness/limescale and other debris. The 3" wide round filter internal was completely clogged with debris and some of the filter holes we crystallized with water limescale. The pump was in good shape but all the filters and parts just needed to be cleaned. Some useful tips on this Magtag Jet Clean... Read more
Installed door latch assembly with switch contacts supplied with the assembly. After troubleshooting, found out it was only 1 of 2 switch contacts that were bad. Read more