Mdb58600awb Parts

Ordered the new o-rings for the pump housing and main filter screen unit. Cleaned all water hardness and other debris out of all parts. Main filter and inside parts clogged with water hardness/limescale and other debris. The 3" wide round filter internal was completely clogged with debris and some of the filter holes we crystallized with water limescale. The pump was in good shape but all the filters and parts just needed to be cleaned. Some useful tips on this Magtag Jet Clean... Read more

My son fixed it. Problem was one of the spinner pieces had worked itself loose and jammed the large arm from freely spinning. Read more

Still not completed, have to order part #PS11747606. When I receive it, I only have to assemble parts Read more

Killed the power,pulled off knob,removed inner plastic door panel with 7 torx head screws, lifted off black plastic timer cover and removed 3 hex screws, unplugged 2 wiring harnesses and a single wire crimp on plug. Installed the new timer, plugged in the harnesses and the single wire, installed cover and installed the inner door. Ran once so far, seems to work fine. Read more

• Not drying dishes properly

Removed 8 screws that retain inner door to outer door. Removed rinse aid dispenser nut and replaced O-ring around dispenser. Also, removed 2 screws that retain the latch assembly and replaced rubber grommet around latch lever that retains soap dispenser door. Read more

Lower spray bar had what looked like spaghettis blocking & protruding from holes on top. Upon further inspection found to be some type of fiber. Further, inspection revealed fiber came from rinse arm. Ordered a new spray bar from you, arrived in three days. Clean all including filters/spray bar put all back together ran like new. The time listed below includes troubleshooting and a little head-scratching. Read more

Replaced gasket Read more

Bought a pump repair kit and then had to buy a discharge pump housing and a check ball. I could have used some other parts as some were brittle, but they were obsolete. The dishwasher runs quiet and seems to clean well. Read more

The foam was shot on the detergent cup lid. Hard as a rock. Causing caking problems, dribble down the inside wall of the door and leaving lumps of detergent. Cut the door in half wit aviation snips and pulled out the two halves. Discovered at this point that the spring had gone soft. Bought one ahead of time, so I was set. Put the spring on the left pin, put the spring pin in the door, slipped the door into place (open) and put the right pin in with pliers. Door snaps open now. Read more

• Leaking

Removed old gasket. Installed new gasket. Read more