Mdb7100awb Dishwasher Parts

My son fixed it. Problem was one of the spinner pieces had worked itself loose and jammed the large arm from freely spinning. Read more

Ordered the parts, they arrived promptly and fit perfectly. A 3 minute repair! Read more

• Not drying dishes properly

Removed 8 screws that retain inner door to outer door. Removed rinse aid dispenser nut and replaced O-ring around dispenser. Also, removed 2 screws that retain the latch assembly and replaced rubber grommet around latch lever that retains soap dispenser door. Read more

Lower spray bar had what looked like spaghettis blocking & protruding from holes on top. Upon further inspection found to be some type of fiber. Further, inspection revealed fiber came from rinse arm. Ordered a new spray bar from you, arrived in three days. Clean all including filters/spray bar put all back together ran like new. The time listed below includes troubleshooting and a little head-scratching. Read more

Bought a pump repair kit and then had to buy a discharge pump housing and a check ball. I could have used some other parts as some were brittle, but they were obsolete. The dishwasher runs quiet and seems to clean well. Read more

The foam was shot on the detergent cup lid. Hard as a rock. Causing caking problems, dribble down the inside wall of the door and leaving lumps of detergent. Cut the door in half wit aviation snips and pulled out the two halves. Discovered at this point that the spring had gone soft. Bought one ahead of time, so I was set. Put the spring on the left pin, put the spring pin in the door, slipped the door into place (open) and put the right pin in with pliers. Door snaps open now. Read more

Replaced PC board. Easy to remove old board and install the replacement. It doesn't get much easier than this. Read more

• Not drying dishes properly