Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Removed 8 screws that retain inner door to outer door. Removed rinse aid dispenser nut and replaced O-ring around dispenser. Also, removed 2 screws that retain the latch assembly and replaced rubber grommet around latch lever that retains soap dispenser door. Read more
Lower spray bar had what looked like spaghettis blocking & protruding from holes on top. Upon further inspection found to be some type of fiber. Further, inspection revealed fiber came from rinse arm. Ordered a new spray bar from you, arrived in three days. Clean all including filters/spray bar put all back together ran like new. The time listed below includes troubleshooting and a little head-scratching. Read more
Color: white. Measures about 11 inches wide by 4-1/2 inches high.
With my hands and fingers. Didn't need tools. Video was helpful. Read more
This upper dishrack tub wheel attaches to the side of the inner dishwasher tub wall.
Replace with a new part Read more
Replaced gasket Read more
Bought a pump repair kit and then had to buy a discharge pump housing and a check ball. I could have used some other parts as some were brittle, but they were obsolete. The dishwasher runs quiet and seems to clean well. Read more
The foam was shot on the detergent cup lid. Hard as a rock. Causing caking problems, dribble down the inside wall of the door and leaving lumps of detergent. Cut the door in half wit aviation snips and pulled out the two halves. Discovered at this point that the spring had gone soft. Bought one ahead of time, so I was set. Put the spring on the left pin, put the spring pin in the door, slipped the door into place (open) and put the right pin in with pliers. Door snaps open now. Read more
Replaced PC board. Easy to remove old board and install the replacement. It doesn't get much easier than this. Read more
This dishwasher door seal is used on some Amana, Maytag, Magic Chef, Crosley, Samsung, Admiral and Jennair dishwashers.
Removed old gasket. Installed new gasket. Read more
Tested starter capacitor at 2.16µF. pic: http://s29.postimg.org/e05fufxdz/IMG_20150716_140312.jpg It should be 15µF. pic: http://s29.postimg.org/x3yrasa87/IMG_20150718_112327.jpg Contrary to service manual, capacitor is not accessible behind the toe/kick-plate; it is underneath but all the way towards the rear. To get to it, the dishwasher has to be removed and positioned face-down (drain first, use towels/drop-cloth). Read more
Front
Simple remove and replace with a simple flathead screwdriver 5 min Read more