Mdgc300bw/Aa Parts

Replaced dried crumbling rubber foot. Cleaned inside and outside of dryer before installing igniter cleared vent hose. Leveled unit installed dryer igniter. Fired it up.Runs Great Now. Read more

Replaced the Injector valve, nozzle and sleeve-in using new hose clamps Read more

I have a Maytag washer that is over 30 years old and still runs like a top. When the siphon break got destroyed in our move, I was able to find a replacement kit that fixed our problem. I found a video on UTube that showed us just what to do. I'm delighted I didn't have to buy a new washer since the quality of new ones doesn't hold a candle to the quality of my Maytag. Read more

This was my first ever self appliance repair. The videos provided by Appliance Parts Pros were excellent and gave me the confidence to do the work myself. My Maytag dryer model opened differently than the one in the videos. I had to remove the front panel and screwing in the paddle required reaching way back and working in a small space where I couldn't see what I was doing. It was uncomfortable but doable with a nut driver and a bit of elbow grease. The part fit perfectly and it looks good as... Read more

Purchased timer and baffle, and my appliance repairman installed them. I could get the parts cheaper than he could from his supplier; he asked me for the Appliance Parts Pros website address! Read more

Replacing the idler arm and the bearing. Read more

I had to replace the terminal block due to the 220 volt ark. A small fire at the bottom of the dryer caused the belt to partially burn. I had to replace it along with the 220 volt dryer cable. If the local hardware store would have taken the time to install the dryer with an additional 0.50 cent grommet, this could have been avoided. Thank you for sending the correct parts. This was the second time I had to use your service and I will continue to use it in the future. Read more

Be careful not to tighten or twist the small hex nut in the knob cylinder/housing with force. there is a very small plastic set tab that can be broken off easily. how do I know? The orientation of the switch "box" is horizontal instead of vertical. otherwise, this replacement part # works as expected. I couldn't get the switch to attach plate removed, and the switch removed, without removing the entire cooktop and removing the top glass burner cover. Not difficult, but time-consuming. Read more

The nylon slides on the front felt seal were worn out, allowing the drum to sag in the front. This is where our clothing would get caught and scorch. I replaced the felt, rear bearing kit and while I was that far, I replaced the belt as it's very inexpensive. All done for less than 10% of a new dryer purchase. Read more

Ordered a new timer from Appliance Parts Pro.com. When it came to me "on time" I installed the part and good to go. Also thank you very much for the cross over guide. My dryer was a Maytag and the Whirlpool part number worked as suggested. Read more