Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
The diffuser has something like a fan underneath that had gone separate from the body. The fan arms were chipped underneath. I thought that might have lead the spray arm to tilt and brush the heat coil, leading to melting on the sides. So, I changed the Diffuser & Lower Spray Arm. I think now the spray arm is parallel and staying above the heat coil. Hopefully it stays that way! Read more
Bought the pump seal kit from AppliancePartsPros.com. Arrived in just a couple days. The job went easier than expected, everything was accessible from the inside Read more
Replaced the heater element, per the video. Also had to connect a new terminal to one of the heater element wires. Once the heater was again connected electrically, the washer completed the entire wash cycle without hesitation. (During the time that the heater element was non-functional, the control "dial" would stop near the bottom, about half way through the cycle, and had to be advanced "one click" manually). The Heater Terminal Shield goes over the Heating Element Nut better if you... Read more
I knew the detergent dispenser was broken. That was an easy fix - though I did find that the retaining pin was too big, and I had to make the hole in the shaft a little bigger. As far as the noise, I started disassembling and cleaning things, until I found that the diverter had broken free from the top of the housing, and was now stuck on the motor. I could see marks from where the diverter had been grinding away the housing. I was worried about prying on the motor (the diverter was very... Read more
No.10 - 16 x 3/8
10 - 16 x 3/8 , hex
Ordered a new tub gasket and baffle seal. Baffle seal replacement required removal of the door. Not too difficult. Tub gasket replacement was easy until I tried to shut the door. The new gasket was a little thicker than the original. The door would not latch. I elongated some holes on the strike - still not enough. I removed some material from the latch mechanism (plastic) with a coarse file. This was enough to allow the door to shut and set the switch. For someone not handy, this would be... Read more