Mds2758dr Parts

Red

This inner door assembly replaces the damaged or cracked inner panel on your refrigerator/freezer door to restore a clean interior surface and proper component mounting. It's the factory-style inner panel used behind the outer door skin. What it does:

• Forms the interior surface of the door and provides mounting points for bins, shelves, and hardware
• Restores a smooth, sanitary interior when the original panel is cracked, warped, or separated
• Helps keep door components aligned to prevent rattling or improper sealing
• Compatible with OEM door hardware and trim when original mounting points are intact

• Installation requires removing the door and outer door trim; handle screws and wiring may need to be disconnected
• Inspect and transfer any clips, gaskets, bins, or fasteners from the old panel
• Use proper support to avoid dropping the door; get a helper for safe handling of heavy doors
• Disconnect power and follow manufacturer safety instructions before servicing

Color: Black/natural. Nylon

This replacement fan blade circulates air inside the appliance to help maintain proper cooling and airflow. A direct-fit blade restores air movement for consistent temperature distribution and efficient operation. What it does:

• Spins on the motor shaft to move air across the evaporator or condenser for cooling
• Helps prevent hot or cold spots by promoting even airflow through the compartment
• Can reduce frost buildup and assist the compressor by improving heat exchange
• Worn or damaged blades may cause vibration, noise, or reduced cooling performance

• One replacement fan blade

• Disconnect power before servicing to avoid electrical shock or injury
• Handle the blade carefully to avoid bending; balance issues can cause noise or motor strain

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation

This pump gasket seals the connection between the appliance pump and housing to help prevent leaks and keep water flowing where it should. A simple replacement that restores a watertight pump interface. What it does:

• Creates a tight seal at the pump housing to stop water from leaking
• Helps maintain proper drain flow by preventing bypass leaks
• Commonly replaced when you see puddling or moisture under the appliance
• Can prevent intermittent draining issues caused by a compromised seal

• One pump gasket

• Disconnect power and water supply before starting any repair
• Inspect mating surfaces and clean debris before installing the new gasket
• Ensure the gasket seats fully and pump/housing fasteners are torqued to spec

This wiring clip secures a refrigerator's wire harness to the cabinet or components to prevent chafing and keep wires organized. It helps maintain safe routing and reduces strain on electrical connections. What it does

• Holds wiring harness in place to prevent rubbing against sharp edges or moving parts
• Keeps wires organized to reduce the risk of pinching or accidental disconnection
• Helps prevent intermittent electrical faults caused by loose or strained wiring
• Commonly used near compressor, fan, control box, or rear cabinet areas

• Install by snapping the clip onto the cabinet flange or component and routing the harness through the retainer
• Disconnect power before accessing electrical components or wiring
• Inspect surrounding wiring and insulation; replace any damaged wire or harness tape before reinstalling the clip