Me302ep/07 Parts

Replace your wall oven's broken or snapped door bracket. This mounting bracket secures the lower oven door panel and attaches door clips for proper alignment.

This shaped handle cap covers the end of a dishwasher door handle to restore a finished look and protect the handle connection. It keeps the door appearance consistent and hides the fastener area for a clean, finished fit. What it does:

• Replaces a damaged, cracked or missing handle end cap to restore appearance
• Covers and protects the handle mounting point from dirt and wear
• Prevents sharp edges or exposed fasteners on the door handle
• Matches the original profile so the handle closes and looks correct

• High-level replacement; may require removal of the door trim or handle screws—refer to your model's service instructions
• Disconnect power and water to the appliance before starting work to avoid injury
• Handle with care to avoid scratching painted surfaces; use appropriate trim tools if needed
• If fasteners are damaged, inspect and replace them with OEM-recommended hardware

This grille for pan is a replacement trim piece that restores proper airflow and appearance around the appliance pan. It helps keep the pan area protected and looking finished after repair. What it does:

• Covers and ventilates the pan opening to help direct airflow and prevent debris entry
• Replaces a cracked, warped, or missing grille to restore fit and finish
• Helps eliminate rattling or rubbing caused by a damaged trim piece
• Matches OEM fit so it installs cleanly with the original mounting points

• Install requires removal of the surrounding trim or access panel; follow your appliance manual
• Handle carefully to avoid scratching the finish; use non-marring tools as needed
• Disconnect power to the appliance before working in the service area
• Replace damaged clips or screws with OEM fasteners for secure fit

This shaped handle cap covers and finishes the end of a compatible appliance handle, restoring a clean appearance and helping protect the handle edge from wear. Fits as a direct replacement for a worn, cracked, or missing end cap. What it does:

• Covers the exposed end of the handle for a finished, factory look
• Protects the handle end from chips, scratches, and snagging
• Helps keep the handle grip comfortable and secure
• Restores cosmetic appearance after impact or wear

• Installer tip: this cap typically snaps or slides into place; remove any broken pieces before installing
• Use a plastic trim tool or gloved hand to avoid scratching surrounding surfaces
• Do not force excessively; if the cap does not seat easily, inspect the handle for damage or mounting clips

90-degree connector cable for ovens and cooktops. Replaces damaged, frayed, or missing connectors. Essential for secure electrical connections.

This cable harness connects key electrical components to restore power and signal flow in the appliance. It replaces a damaged or faulty wiring harness to help return controls and components to normal operation. What it does:

• Carries power and control signals between the control board and components
• Replaces frayed, burned, or broken wires that cause intermittent or no operation
• Common symptoms it can address: appliance won't start, controls unresponsive, intermittent cycles, or error codes related to open/shorted circuits
• Helps ensure secure connector mating and correct signal routing when installed properly

• Disconnect power at the breaker or unplug the appliance before starting any repairs
• Compare the new harness to the old one and follow the appliance wiring diagram for correct routing and connector placement
• Secure connectors fully; avoid sharp bends or pinching the wires during reassembly

Oven not heating or controls unresponsive? This cable harness restores power connections between controls and components, fixing intermittent failures.

This spacer is a small structural component that maintains proper clearance between oven parts. Replace if broken, missing, or worn to ensure correct spacing.