Med8570tw0 Parts

This kit includes the components needed to reverse the swing direction of the dryer door from one side to the other. It is useful when repositioning the dryer in a new location where the current door swing is inconvenient. The kit typically includes the door, hinge hardware, and any necessary trim pieces for a complete reversal.

Replaces worn or damaged lower cabinet base that supports your dryer frame. Needed when the original base is cracked, broken, or missing. Restores stability.

This is a metal flange bracket that secures the heater housing assembly inside the dryer. It holds the heater box in the proper position to ensure safe and efficient heat distribution during drying cycles. Replace this bracket if it is bent, corroded, or broken, which can cause the heater housing to shift and lead to overheating or unusual noises.

Internal wire harness assembly that connects dryer components for signal and power flow. Replace if wires are cracked, frayed, or connectors are damaged.

Complete dryer door assembly that installs on the front panel. Replace if your door is cracked, damaged, won't seal properly, or the window is broken.

Exposed wiring at the back of your dryer? This terminal block cover shields electrical connections from accidental contact and debris. Simple snap-on install.

This cable tie secures wiring and the power cord to the appliance chassis to help prevent chafing, pinching, or loose connections. Simple, low-cost part that restores proper wire routing and strain relief. What it does

• Holds wiring and harnesses in place to prevent rubbing against sharp edges
• Helps reduce risk of intermittent power or connector strain caused by loose wires
• Keeps harnesses routed for correct clearance and component access
• Useful during repairs to restore original wire routing and strain relief

• One cable tie (wire harness retainer)

• Safety first: disconnect the appliance from power before inspecting or replacing wiring components
• Remove the damaged or existing retainer and route harnesses to match original OEM routing before installing the new tie
• Trim excess tie tail; do not overtighten—secure, but avoid crushing wires
• Replace any tie that's melted, cracked, or otherwise damaged rather than reusing it

Exhaust vent elbow routes hot air and lint from your dryer to the external vent. Replace if cracked, bent, or leaking to restore airflow and safety.

If your dryer takes forever to dry clothes or feels overly hot, a clogged or damaged exhaust pipe may be restricting airflow. Direct replacement part.

Sound absorber insulation pad for dryers. Installs inside cabinet to dampen noise and vibration. Replace if torn, compressed, or missing.

Dryer seal that prevents air leaks and maintains proper airflow. Replace if you notice excessive lint buildup or reduced drying efficiency. Verify fit with your model number before ordering.

This is a foam seal that fits along the control panel area of a dryer, creating a barrier against moisture, lint, and air leaks. It helps protect internal control components from heat and debris. Replace this seal if it is cracked, compressed, or missing, which can allow lint buildup near controls or cause air leaks that reduce drying efficiency.

Fixes dryer that won't start or hums but doesn't spin. This run capacitor provides the motor boost needed to turn the drum. Moderate 30-minute repair.

Replacement trim panel for your dryer. Installs on the cabinet to cover edges and gaps. Order a new one if your original is cracked, chipped, or missing.

Mounting bracket for dryer assembly. Secures components in place during operation. Replace if bracket is bent, cracked, broken, or missing hardware.