Medb50wq0 Parts

Dryer not drying or taking too long? A cracked blower housing disrupts airflow. This assembly restores proper venting for efficient drying cycles.

If your dryer won't start, cycles won't change, or display lights stay on, the electronic control board may be faulty. Moderate DIY repair.

Dryer won't start or stops mid-cycle? A faulty door switch prevents operation when the door signal fails. Direct replacement, basic tools required.

For mating terminal use [AP31136300].

Dryer drum seal prevents heat loss and improves efficiency. Replace if you notice excessive lint, reduced drying performance, or visible wear. Confirm fit with your model number.

Replaces cracked, damaged, or worn dryer inner door panel. Restores door appearance and structural support. Essential for maintaining a clean finish.

Replace your dryer door seal to restore a tight gasket and prevent air leaks. If your seal is cracked, torn, or worn, this part ensures secure closure. Confirm fit with your model number.

Replace your dryer's damaged, dented, or cracked outer door panel. This finished surface panel installs on the front door assembly to restore appearance.

Replacement cover panel for dryers. Installs on the exterior housing to restore appearance and protect internal components when original is cracked or damaged.

Replacement top panel for dryer cabinet. Restores the outer cover and protects internal components. Needed when original is cracked, dented, or damaged.

If assemblies shift or rattle during dryer operation, this snap-down locator clip secures components in place. Simple snap-in installation restores alignment.

Directs exhaust airflow from your dryer to the external vent. Replace this duct pipe if worn, damaged, cracked, or missing to restore proper ventilation.

This hose kit replaces worn or damaged appliance hoses to restore proper water flow and prevent leaks. It's a direct-fit replacement for compatible Whirlpool systems and helps stop visible leaks and restore normal fill/drain operation. What it does

• Replaces cracked, split or leaking hoses to stop water loss and reduce risk of appliance damage
• Restores reliable water flow for filling and draining functions
• Helps eliminate poor draining, intermittent filling, or water pooling near the appliance
• Works with existing clamps and connections when installed correctly

• Disconnect power and shut off the water supply before starting any repair
• Inspect connection fittings and replace clamps if worn; ensure a snug, leak-free fit
• Route hoses without kinks and secure to avoid chafing or strain
• After installation, run a short cycle and check all connections for leaks

This OEM part is a control board for washers. The control board is the main computer that controls the essential functions of the washer. If the washer is not rinsing, draining, or spinning properly, or does not turn on, it might mean it's time for a new board. Luckily replacing the control board is a relatively simple process.First, make sure to unplug the washer and pull it out to gain access to the back. Remove the upper back panel and locate the washer's control board. Take note of the orientation of the wires with a phone camera. Disconnect the wire harness and remove the individual wires off the old control board. Re-insert the wires into their correct terminals on the new control board. Snap the new unit back into its original place. Reinstall the upper back panel and move the washer back in place. This genuine replacement OEM control board is compatible with Whirlpool, Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Sears/Kenmore brand washers. It is sold individually.

This is the rear bulkhead panel that forms the back wall of the dryer drum housing. It provides structural support for the drum and helps seal the drying chamber to maintain proper airflow and heat. Replace this part if the dryer is making unusual noises, the drum wobbles, or you notice heat escaping from the rear of the unit.

Wire harness for dryers and laundry centers. Connects electrical components inside the cabinet. Replace if wires are frayed, damaged, or burnt.