Met8720dh Parts

This panel spacer provides a small trim/mounting gap between cabinet panels and control or door assemblies to ensure proper alignment and a finished appearance. It helps stabilize panels and prevents rubbing or interference. What it does:

• Positions and spaces exterior or trim panels for correct fit and alignment
• Helps reduce panel vibration and rattling during operation
• Prevents panels from contacting adjacent parts that can cause wear or noise
• Restores original panel gap after panel removal or replacement

• One panel spacer as shown

• Install with appropriate screws or clips; only use the mounting hardware specified for your model
• Power off and unplug the appliance before accessing panels to avoid injury
• Handle panels carefully to avoid scratching finish; use a soft cloth or protective pads

This rear cover replaces the dryer's rear panel to protect internal components and restore the unit's enclosure. It helps keep wiring and components shielded while maintaining proper airflow and appliance appearance. What it does:

• Protects internal wiring, terminals and components from dust and damage
• Provides the enclosure for the dryer's rear area and vent connection points
• Reduces rattling and drafts caused by a cracked or missing rear panel
• Helps prevent excess lint accumulation around rear components

• Disconnect power (and gas supply if applicable) before servicing
• Remove the dryer from the wall and lay it on a protected surface to access the rear
• Typical installation requires removing screws and aligning the cover before fastening; use basic hand tools
• Watch for sharp edges and take care not to pinch wiring or hoses during reassembly

Replacement hinge receiver for range oven doors. Secures the door hinge to the frame. Replace if cracked, broken, or worn to restore proper door support.

Replace your range oven door window frame if cracked, broken, or missing. This structural component holds the glass in place on the oven door assembly.