Mfi2260vew7 Parts

This water filter cover secures and seals the refrigerator's replaceable water filter, helping maintain correct water flow and prevent leaks. It restores a snug fit after filter changes for reliable dispensing. What it does:

• Secures the replaceable water filter in its housing and holds it in place
• Seals the filter area to help prevent water leaks around the filter
• Directs water through the filter for proper flow and filtration
• Can resolve symptoms like a loose or unseated filter, leaks near the filter housing, or difficulty installing the filter

• Turn off the refrigerator water supply and dispense remaining water before starting
• Remove the existing filter per manufacturer instructions, then position and snap or twist the cover into place
• Inspect filter O-rings and housing for damage; replace damaged seals before reinstalling

This door closer restores smooth, controlled closing for the appliance door. It helps prevent slamming and keeps the door aligned for a better seal and reliable operation. What it does:

• Guides and cushions the door during closing to reduce slamming and wear
• Helps maintain proper door alignment for an effective seal and temperature control
• Reduces stress on hinge components and latch mechanisms
• Commonly replaces worn or broken closers that cause noisy, uneven, or loose door movement

• One door closer

• Disconnect power before starting work and follow appliance-specific service instructions
• Removal may require access panels or partial disassembly of the door/hinge
• Inspect surrounding hinge and mounting hardware and replace if damaged

Color: Bisque Note: Set screw on side of handle end, is not available separately.

This replacement drip tray catches and channels condensation or small leaks to keep the area under your appliance dry and reduce the risk of water damage. It restores proper drainage and helps prevent pooling beneath the unit. What it does:

• Collects condensation and minor leaks to prevent water from reaching the floor or cabinet
• Directs water to the appliance's drain area so moisture evacuates properly
• Helps reduce odors and mold growth caused by standing water
• Common symptom fix: visible puddling or dampness beneath the appliance

• Disconnect power (and water, if applicable) before starting any repair
• Drain any standing water and work with towels to catch residual moisture
• Installation typically requires removing lower access panels or the kickplate; keep fasteners organized

This wire cover protects appliance wiring from heat, abrasion and pinching to help prevent shorts and electrical faults. It's a direct-fit replacement used where wiring needs routing and protection near panels or heating components. What it does:

• Shields wiring from heat, sharp edges and moving parts to reduce wear and risk of electrical contact
• Helps prevent intermittent electrical problems caused by chafed or pinched wires
• Reduces risk of smell, burning or smoke from wires contacting hot surfaces
• Keeps wire bundles neatly routed for safer operation and service access

• One wire cover

• Disconnect power (unplug appliance or switch off circuit breaker) before servicing
• Remove access panels as needed to reach the damaged or missing wire cover
• Slide or clip the cover over the wiring harness and secure with existing fasteners; replace any damaged clips or retainers
• If wiring shows damage, replace the wiring harness or repair per manufacturer instructions before reinstalling the cover