Msc2651kgb Parts

This ice container (ice bin) stores ice made by the icemaker and interfaces with the dispenser drive to deliver cubes or crushed ice. Replacing a cracked or worn bin restores dependable ice storage and dispensing performance.

• Holds finished ice and guides it to the dispenser chute
• Engages the drive to move ice out when the dispenser is activated
• A cracked, warped, or stripped bin can cause no/slow ice dispensing or jams
• Damage may prevent the bin from seating fully or allow ice to spill/frost up

• Unplug the refrigerator or switch off power at the breaker before servicing
• Remove the old bin, clear any clumped ice, and seat the new bin so the rear drive interface engages—do not force
• Restore power and allow the icemaker to produce ice before testing dispensing

Replace a cracked or yellowed freezer light lens that makes it hard to see inside. This cover diffuses light evenly and protects the bulb. Quick fix.

This is a rear panel cover that attaches to the back of the refrigerator, enclosing and protecting internal components. It helps maintain proper airflow and keeps dust and debris away from mechanical and electrical parts. Replace this cover if it is cracked, warped, or missing, which can lead to reduced cooling efficiency or excessive noise.

Secures panels, brackets, and internal components in your refrigerator. Replace missing, stripped, or corroded screws to restore tight assembly fit.

Replace your cracked or broken refrigerator door shelf bin. This storage compartment mounts inside the door to organize gallon-size items and maximize space.

Cracked or missing refrigerator light lens? This cover protects the bulb and diffuses glare in the fresh food section. Simple snap-in installation.

Plastic tray that installs below the ice and water dispenser to catch spills and drips. Replace if cracked, broken, or missing to prevent leaks.

This replacement lid fits the refrigerator utility/bin drawer and restores a secure cover to keep stored items contained and organized. It replaces cracked, broken or warped lids so the bin functions as intended. What it does:

• Covers and protects items stored in the utility/bin drawer
• Replaces lids that are cracked, chipped or no longer latch properly
• Helps prevent items from shifting or falling into other compartments
• Restores a proper seal and alignment of the utility/bin cover

• Unplug or disconnect power to the appliance before servicing for safety
• Remove the bin/drawer per the manufacturer instructions to access the lid
• Align hinge tabs or mounting points and snap or fasten the lid into place
• Handle carefully; plastic edges or mounting points can be fragile during installation

This thermostat retainer clip secures the defrost thermostat to the evaporator tubing in your refrigerator or freezer, maintaining firm contact for accurate temperature sensing and dependable defrost operation.

• Holds the thermostat firmly against the evaporator line for proper temperature feedback
• Helps prevent a loose or dangling thermostat that contribute to frost buildup and poor defrost performance
• Restores correct mounting when the original clip is cracked, bent, or missing
• Common signs include a broken clip or a thermostat not attached to the coil

• Disconnect power to the appliance before servicing; wear cut-resistant gloves
• Access the evaporator compartment; remove accumulated frost/ice as needed without prying on coil fins
• Position the thermostat body flat against the tubing and snap the retainer over it, avoiding pinched wires or damaged fins
• Confirm a secure fit and proper wire routing before reassembling and restoring power

Rubber grommet kit that mounts and cushions the compressor. Replace worn, cracked, or damaged grommets to restore proper support and isolation.

This is a push button cap that fits over a switch on a range or oven control panel. It serves as the external interface that you press to activate a specific function such as ignition or lighting. Replace this cap if it is cracked, missing, or no longer staying in place, making it difficult to engage the underlying switch.

Main wire harness that routes power between the control board and components. Replace if wiring is damaged, burned, or connector clips are broken.