P2bb Parts

This manifold pipe routes gas from the range's valve assembly to the individual cooktop burners, restoring safe and consistent fuel delivery for reliable burner operation. Replace a damaged or corroded manifold to stop leaks and restore proper flame distribution. What it does:

• Channels gas from the control valve block to each burner for ignition and steady flames
• Helps maintain even burner performance and consistent heat across the cooktop
• Failsafe for preventing gas leaks when intact; visible damage, corrosion, or cracks can cause unsafe operation
• Commonly replaced when burners won't light, show weak or irregular flames, or after leak detection

• Turn off the gas supply and unplug the appliance before servicing.
• Inspect and replace any damaged seals, gaskets, or fittings when installing the manifold.
• Test for leaks with a soap solution or approved leak detector after installation; do not use an open flame.

This tube dual valve controls water flow through the appliance's tubing assembly, allowing proper delivery of water where the unit needs it. Replaces a worn or leaking valve to restore normal water supply and prevent leaks. What it does:

• Diverts or stops water flow through the machine's tubing when a valve is activated
• Helps prevent leaks caused by cracked, stuck, or corroded valve components
• Commonly used when the appliance doesn't fill, fills slowly, or constantly runs water
• Works as the plumbing control point for timed or solenoid-operated water delivery

• One tube dual valve

• Disconnect power and shut off the water supply before beginning work
• Handle tubing fittings and seals carefully to avoid damage and leaks
• Confirm the valve orientation and tubing routing match the original during reassembly

Mounting bracket secures oven components inside your range. Replace if bracket is bent, cracked, broken, or missing to restore proper structural support.

Replace worn felt pad gasket to prevent heat loss and reduce noise in your range. Cushions components and ensures proper sealing. Confirm fit with model number.

This back cover protects the appliance's rear components and wiring, keeping internal parts secure and reducing exposure to dust and debris. It restores the cabinet's finished appearance and helps maintain safe operation. What it does:

• Covers and shields rear-mounted electrical components and connections from dust and accidental contact
• Helps reduce vibration noise and prevents loose parts from rubbing or striking internal components
• Prevents debris and small objects from entering the appliance chassis
• Visible cracks, missing tabs, or warping can allow rattling or expose wiring — replacing the cover restores protection

• One back cover (rear panel) as shown

• Disconnect power (and gas, if applicable) before beginning any work
• Typical installation uses screws or retaining tabs; keep removed fasteners for reassembly
• Be careful of sharp sheet-metal edges; wear gloves and eye protection

This back cover is the rear access panel that protects internal components and wiring and helps maintain proper airflow. It restores a finished exterior and shields parts from dust and damage. What it does:

• Covers and protects rear-mounted components and wiring
• Prevents debris and dust from entering the appliance back area
• Helps maintain proper airflow and enclosure integrity
• Visible cracks, missing fasteners, or exposed wiring are common reasons to replace

• Disconnect power (unplug or switch off breaker) before servicing
• Remove mounting screws to take off the old cover; retain screws if still usable
• Handle edges carefully—panel edges may be sharp
• If you see damaged wiring or other component problems, stop.

Replace your range's back lower cover panel if it's cracked, broken, or missing. This protective housing installs on the rear lower section of your range.

Replace the upper back cover panel on your range. This housing component protects internal parts and completes the exterior. Order now if damaged or missing.

Back lamp housing cover for gas ranges. Protects the back lamp assembly from damage. Replace if cracked, broken, or missing to restore proper coverage.