We use cookies and similar tools for site analytics and advertising. By using our site, you agree to this. See our Privacy Policy for details. Do Not Sell or Share My Personal Information
Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Usually ships within 4 - 14 days
Rubber grommet seals the ice maker fill tube where it enters the refrigerator cabinet. Replace if cracked, brittle, leaking, or missing to restore seal.
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,... Read more
This light shield is the clear cover over the fresh food compartment light. It diffuses brightness and protects the bulb or LED from bumps, restoring even illumination and a finished look inside your refrigerator.
What's included: One light shield for the fresh food compartment. Install notes:
I ordered the part and it fit perfectly. Read more
This articulation mullion is the flip-out center rail on a French-door refrigerator. It swings into place as the door closes to seal the gap between doors, helping maintain proper temperatures and limit moisture around the center joint.
I pulled out the cracked shelf and laid it on the kitchen table. I laid the new shelf next to it, and one by one, moved each part from the old to the new. The whole process took about 15 minutes. I took it slow to make sure that I got it right. The new part was the exact unit for my refrigerator. Read more
Easily found the divider and a mount for the base bar online - both were cracked by the accident. Had to remove the freezer well which seemed impossible until I gained enough room by opening the refrigerator doors (duh!). It would have been much easier if I would have removed the freezer door, but couldn't figure our how, so I contorted myself in to screw the divider in to the top of the freezer. Then added the bottom bar by lifting it into place from below with it nestled in one side.... Read more