Pgr364glzs/01 Parts

This electronic PC board is the appliance's main control, processing inputs and directing power to components so cycles run correctly. Replacing a failed board can restore normal operation when the unit is dead, won't start, or stops mid-cycle.

• Interprets user inputs and sensor feedback to execute programmed cycles
• Switches relays to power motors, valves, heaters, and other loads as required
• Manages timing, temperature, and safety logic for consistent performance
• Typical failure symptoms: no power/won't start, unresponsive or erratic controls, cycles ending prematurely, recurring error codes

• Disconnect power before servicing; verify power is off with a meter
• Use ESD protection; handle the board by the edges to avoid static damage
• Move connectors one at a time to identical positions on the new board to prevent miswiring
• Some models require service-mode setup or calibration after installation—follow your model's service documentation

This compression sleeve forms the sealing ring for a 5/16-inch tubing compression joint, restoring a watertight connection when used with a matching compression nut and fitting. Ideal for stopping leaks and restoring reliable water lines. What it does:

• Creates the compression seal on 5/16" tubing when installed with a compatible compression nut and fitting.
• Stops leaks or drips at compression-style water connections.
• Used on appliance water lines (ice makers, water inlets) and other 5/16" tubing joints.
• Replaces worn or damaged sleeves that fail to hold a tight seal.

• Shut off the water supply and relieve pressure before working on water lines.
• Inspect and cut tubing squarely; slide the sleeve onto the tube before threading the compression nut and fitting.
• Tighten the compression nut per the fitting manufacturer's instructions and check the joint for leaks.
• Replace the sleeve if damaged or deformed.

Burner won't light or clicks continuously? This spark ignition module generates the voltage needed to ignite gas burners. Moderate DIY repair.

Secures 5/16-inch gas tubing to compression fittings. Replace if leaking, loose, or damaged during service. Verify tubing size before ordering.

Fix leaks or flow issues in your range with this routing tube. Replaces worn or cracked tubes to restore proper liquid and airflow in your appliance.

Replace your cracked or faded control panel insert trim to restore appearance and proper button alignment. Fits into the control area for a clean look.

Control panel trim insert that covers and protects the console area. Replaces cracked, scratched, or cosmetically damaged trim for a clean, finished look.

Black slimline control knob for your range. Installs on the control panel to replace worn, cracked, stripped, or missing knobs and restore secure grip.

Internal electrical wire for ranges. Connects electrical components within the appliance. Replace if wire is damaged, frayed, or connection is loose.

Replace your worn range door seal gasket to restore proper sealing and prevent heat loss. This flexible gasket creates a tight barrier around the door edge. Confirm fit with your model number before ordering.

Saddle clamp secures gas lines and wiring on cooktops and ranges. Replace if cracked, loose, or missing to prevent rattling and ensure safe operation.

Replace a cracked, broken, or missing control knob on your range cooking surface. This knob installs on the control panel to restore full appearance.

Replace your range's worn, cracked, or missing control knob. This knob installs on the front panel to operate burners and oven controls. Direct fit part.

Burner support for gas ranges. Mounts under the cooktop to hold burners in place. Replace if cracked, bent, or missing to properly secure burner assemblies.

Replace a cracked or missing spacer for your gas range. This small structural component helps maintain proper spacing between parts during installation.