Pgs688semss Parts

This spacer base positions and supports components inside the appliance to maintain correct alignment and clearance, helping reduce vibration and wear. It's a simple replacement part when the original is cracked, broken, or missing. What it does:

• Provides a stable mounting surface and correct spacing for internal panels or components
• Restores proper alignment to reduce vibration, noise, and uneven operation
• Commonly replaced when the original spacer is cracked, deformed, or missing
• Helps maintain secure fastener engagement and proper component clearance

• Spacer base (single piece)

• Disconnect power to the appliance before starting any repair
• Follow manufacturer service instructions or parts diagram for correct location and orientation
• Basic hand tools typically required; inspect surrounding fasteners and mounting surfaces during installation

This bake burner is the oven's heat source for baking cycles, replacing a worn or damaged burner to restore consistent bake performance and even cooking results. Designed to match OEM fit and function. What it does:

• Provides the main heat for the oven's bake mode so food cooks through and browns properly
• Helps maintain even temperature distribution across the oven cavity
• Common replacement for symptoms like weak or no bake heat, uneven baking, or burner that won't ignite reliably
• Works with the oven's ignition and gas supply to deliver steady flame when functioning correctly

• Turn off power and shut off the gas supply before starting any repair
• Follow OEM service instructions; verify correct burner alignment and secure mounting before restoring gas and power
• Use caution handling sharp edges and hot surfaces; allow the appliance to fully cool before servicing

This Injet MRHOB assembly is a replacement component designed to restore the original part function in compatible appliances. It replaces a worn or damaged MRHOB assembly to help return the unit to normal operation. What it does:

• Serves as the direct replacement assembly for the appliance's Injet MRHOB component
• Restores mechanical/electrical connection where the original MRHOB has failed
• Can address symptoms such as intermittent operation, loss of function, or component-related error codes when the MRHOB is faulty
• Used when inspection shows the existing MRHOB is cracked, corroded, or otherwise damaged

• One Injet MRHOB assembly

• Install only after disconnecting power to the appliance to avoid shock or injury
• Refer to the OEM installation instructions for correct placement and wiring
• Use proper tools and replacement practices

The High Voltage Electrode and Harness Assembly is an OEM part for GE dual fuel ranges. It carries electrical current to spark gas pilots and oven/broiler ignitors. 

Symptoms of a faulty HV electrode and harness include:

• Pilot lights extinguishing or failing to light 
• Inconsistent ignition of gas burners and heating elements
• Arcing sounds emanating from the range top or oven areas

Causes involve cracks in porcelain insulators from thermal stress, worn electrodes after prolonged sparking, or wire insulation degraded by ambient heat over time.

This OEM part is also compatible with Hotpoint and RCA dual fuel range models.

This dual plunger switch completes dispenser controls when the dispenser lever is pressed, restoring proper water and ice dispensing response. It replaces a worn or failed dispenser actuator switch to help the dispenser register lever movement. What it does:

• Acts as the dispenser lever switch assembly, closing circuits when the lever/plunger is depressed
• Controls water and/or ice dispense signals to the dispenser control board or valve
• Commonly linked to symptoms such as no water or ice when pressing the dispenser, intermittent dispensing, or unresponsive dispenser lever
• Helps restore reliable electrical contact for dispenser operation when the original switch is faulty

• One dual plunger switch assembly

• Disconnect power to the appliance before beginning any work
• Shut off water supply if removing water-connected components near the dispenser
• Access typically requires removing the dispenser bezel or front panel to reach the switch; handle panels and connectors gently
• Reconnect wiring exactly as removed and verify operation before reassembling all panels