Plcb999cc0 Parts

This thermoprotector switch is a safety device that monitors oven temperature and cuts power to the heating element if the oven exceeds safe operating temperatures. It helps prevent overheating and potential damage to the oven's components. Replace this switch if your oven shuts off unexpectedly, fails to heat properly, or if you suspect the thermal safety cutoff is no longer functioning correctly.

Secures cooktop surface elements to your range for stable contact and even heating. Replace if bent or worn to restore proper element positioning.

Hex washer head ,10-32 x 0.375. Ground

Shoulder screw secures oven components with built-in spacer for proper alignment. Replace worn, missing, or stripped fasteners to restore fit.

Range won't heat or overheats? This safety thermostat protects against excessive temperatures. Direct replacement part for reliable operation.

This is the rear panel that mounts on the back of a freestanding range, enclosing and protecting the internal wiring, insulation, and components behind the oven cavity. It helps maintain proper airflow and shields electrical connections from damage. Replace this panel if it is dented, rusted through, or missing, which can compromise insulation efficiency and expose internal components.

If your burner won't light or the flame is too high or too low, this gas valve controls flow to restore proper ignition and flame adjustment on your cooktop.

Replaces the touch pad console panel on your range. This front panel houses the control interface and typically needs replacement when dented or damaged.

A replacement bake ignitor assembly that provides the hot surface needed to ignite the oven's gas burner for consistent baking and broiling. Replaces a worn or cracked ignitor to help restore normal oven heating. What it does:

• Heats to a high temperature so the oven's gas valve can ignite the burner
• Common symptom: oven won't heat or take much longer than normal to preheat
• Common symptom: burner fails to light even when controls are set correctly
• Works with the oven's safety and gas valve system to allow reliable ignition

• Disconnect power and shut off the gas supply before beginning any repair
• Handle the ceramic ignitor tip carefully; avoid touching it with bare hands
• Verify proper electrical connector and mounting fit before final installation

Spacer bumper for cooktops and ranges. Installs between components to provide proper clearance and prevent vibration. Replace if worn or missing.

Mounting screw secures heating element to cooktop surface. Replace if stripped, rusted, or missing to ensure proper element installation and stability.

Oval-head square-drive screw secures interior and exterior oven panels, brackets, and trim. Replace worn, stripped, or missing screws for secure assembly.