Prd304ghu Parts

This rotary potentiometer converts shaft rotation into an electrical signal the control board can read, providing precise position feedback for user selections. Replace it if inputs become erratic, jump between settings, or the control stops responding.

• Provides rotary position feedback to the electronic control
• Enables accurate selection and adjustment of functions or setpoints
• Wear or damage can cause drifting, dead spots, or incorrect readings
• Intermittent or no response to input is a common failure symptom

• Disconnect power before servicing
• Access the control/console area to reach the component
• Note shaft orientation and any connector positions; transfer exactly to the new part
• Handle electronics with ESD care and verify smooth, full-range operation after reassembly

Stabilizing leveling foot for gas ranges. Provides balance and proper elevation. Replace if worn, broken, or missing to restore stability and positioning.

Secures panels and internal components in gas ranges. Replace this fastener if missing, rusted, or stripped to restore proper fit and alignment.

Fix an oven light that won't turn on or a self-clean cycle that won't start. This door switch monitors door position for safety and lighting.

This is an indicator light or display component mounted on the range's control panel that provides visual feedback about oven or burner status. It lets you know when a heating element is active or when the oven has reached the set temperature. Replace this part if the indicator fails to illuminate, flickers intermittently, or displays incorrect information.

This Jet is the small spray nozzle that directs a focused stream of water inside the dishwasher's wash system. Replacing a clogged or damaged jet helps restore proper spray coverage, wash pressure, and overall cleaning performance.

• Directs and meters water flow within the wash system
• Helps maintain spray arm/wash zone pressure and coverage
• Replace if clogged with mineral deposits or physically damaged
• Symptoms include poor cleaning, weak spray, unusual wash noise, or leaks near the nozzle

• Disconnect power and shut off the water supply before servicing
• Access the nozzle location and note its orientation and any seals/clips
• Clean mating surfaces; transfer any reusable seal/clip if present
• Seat and lock the jet fully; run a test cycle and check for leaks

Protective cap that covers openings or fasteners on your gas range. Replace when cracked, broken, or missing to restore a clean, finished appearance.

If your gas range burners won't light or ignite intermittently, a worn ignition cable may be preventing spark delivery. Restores reliable ignition.

This indicator light illuminates to show when a burner or oven element is active or still hot. It is mounted on the control panel and provides a visual safety alert during and after cooking. Replace this part if the indicator fails to light up when a burner is on, stays lit continuously, or appears dim and flickering.

This circular heating element is mounted around the convection fan at the rear wall of the oven cavity. It provides the heat that the fan circulates evenly throughout the oven during convection cooking. Replace this element if the oven does not heat properly in convection mode, heats unevenly, or if the element shows visible damage such as blistering, cracks, or burn-through spots.

Replacement mounting screw for gas ranges. Secures panels, brackets, and internal components to the chassis. Replace if missing, stripped, or damaged.

Factory mounting screw that secures panels, brackets, and internal components in gas ranges and cooktops. Replace when stripped, missing, or worn out.

This is the bake element located at the bottom of the oven cavity, responsible for producing the heat needed for baking and roasting. It is a looped resistive coil that heats up when energized by the oven's control system. Replace this element if the oven is not heating, heating unevenly, or if the element shows visible damage such as cracks, blistering, or burn-through spots.

Small hardware pin that secures or pivots components in gas ranges and cooktops. Replace if worn, missing, or broken to restore proper alignment.

Fix unresponsive range controls with this push-button switch. Restores button function when controls stop working. Simple replacement for worn switches.

Range oven door won't lock during self-clean cycle? This door lock assembly ensures safe operation. A moderately challenging fix with basic tools.