Prg366/1 Parts

This is a round control knob that restores secure grip and accurate control for a range, cooktop, or oven control shaft. Replaces a cracked, stripped, or missing knob so controls turn smoothly and reliably. What it does

• Fits onto a standard control shaft to change heat or function settings.
• Replaces a broken, loose, or missing knob that won't turn or slips on the shaft.
• Restores tactile grip and precise adjustments for temperature or burner selection.
• Helps prevent accidental setting changes caused by a damaged knob.

• One control knob.

• Turn appliance controls to OFF and disconnect power (or gas) before working on the appliance.
• Pull the old knob straight off the control shaft; align splines and push the new knob on until seated.
• If knob resists, verify correct orientation of splines and avoid excessive force.

This door hinge replaces a worn or damaged hinge to restore proper door alignment and operation. It provides a simple, direct swap to stop sagging, rubbing, or doors that won't stay closed. What it does:

• Supports and aligns the appliance door to ensure smooth opening and closing
• Stops door sag, uneven gaps, and contact with the cabinet or frame
• Prevents binding or scraping that can damage the door seal or finish
• Helps restore proper door closure for optimal appliance performance

• Disconnect power and water (if applicable) before beginning any repair
• Support the door during removal and installation to avoid dropping or damage
• Tighten mounting hardware securely and check door alignment after installation

This 48-inch gas supply tube routes fuel from the appliance inlet to the internal gas valve, providing a direct replacement for damaged, corroded or bent factory tubing. Restores safe gas flow when the original tube is compromised. What it does:

• Directs gas from the inlet to the appliance gas valve for ignition and burner operation.
• Replaces tubing that is cracked, bent, corroded or otherwise leaking.
• Addresses symptoms like a persistent gas odor near the appliance, burners that won't light, or visible damage to the original tube.
• Provides the correct length and routing to match the appliance's original configuration.

• Turn off the gas supply and electrical power to the appliance before beginning work.
• After installation, test all connections for leaks with a soap-and-water solution or a calibrated gas leak tester; do not use an open flame.
• Do not modify or shorten the tube; use the correct routed length and fittings for a proper seal.

This bottom cavity cover replaces the removable floor panel under the oven cavity to protect internal components and help contain spills for easier clean-up. It restores the oven's lower interior surface for safe, tidy operation. What it does:

• Covers and protects the oven cavity floor and components from drips, crumbs, and direct heat exposure
• Helps keep the lower oven area clean and makes wiping up spills simpler
• Supports proper airflow path and component protection when installed
• Commonly replaced when the original cover is dented, warped, or damaged

• One bottom cavity cover

• Turn off and disconnect power to the appliance before starting any repair
• Allow the oven to cool completely; use gloves to handle sharp edges
• Installation typically requires removing the oven racks and sliding the cover into position; keep fasteners if present

This distributor rotor assembly routes the ignition signal inside the appliance's ignition module so the correct burner or electrode fires when needed. It helps restore proper ignition sequencing and consistent spark delivery. What it does:

• Rotates or indexes to direct the ignition/spark signal to each electrode in sequence
• Restores correct firing order when a worn rotor causes intermittent or no spark
• Helps eliminate ignition delays, weak sparks, or uneven burner lighting
• Works as the mechanical/electrical link between the ignition module and electrodes

• One distributor rotor assembly

• Turn off power and gas before beginning work; follow appliance-specific safety procedures
• Handle with care to avoid damaging contacts or the rotor tip
• Inspect mating contacts and surrounding components; replace related damaged parts as needed