Prg486jdg/03 Parts

This compression sleeve seals 3/8-inch refrigeration or water tubing where a compression fitting is used, restoring a tight, drip-free connection. It's a simple replacement to stop leaks and ensure a secure joint. What it does:

• Acts as the ferrule inside a compression fitting to compress against tubing and create a seal
• Restores a worn or flattened sleeve that causes leaks at nuts or fittings
• Used with a matching compression nut and fitting to secure 3/8" tubing
• Commonly replaced when connections leak, weep, or fail to hold pressure

• One compression sleeve sized for 3/8 in. tube

• Turn off and depressurize the system (water or refrigeration) before removing fittings
• Cut tubing square and deburr before installing the sleeve for best seal
• Slide the nut then the sleeve onto the tube, seat against the fitting, and tighten to manufacturer torque
• Inspect the joint for leaks after pressurizing and retighten if needed; replace sleeve if damaged during installation

This replacement bracket secures the griddle igniter/electrode so the igniter stays positioned for reliable spark near the griddle burner. Restores correct igniter alignment to help the griddle light properly. What it does:

• Holds the igniter electrode in the correct position next to the griddle burner for consistent ignition.
• Keeps the igniter stable to prevent misfires, intermittent lighting, or weak sparks.
• Prevents igniter movement or contact with other components that can cause damage.
• Helps restore normal griddle lighting when the original bracket is broken, bent, or missing.

• Disconnect power and shut off the gas supply before beginning any service.
• Handle the igniter electrode and ceramic insulator carefully; avoid touching the ceramic surface with bare hands.
• Secure mounting hardware; do not overtighten screws.
• After installation, reconnect power/gas and test for proper ignition; check for gas leaks using a soap solution if gas connections were disturbed.

This connector strip is the wire terminal block that joins appliance wiring harnesses for reliable electrical connections, helping restore power and control signal continuity. It's a direct-fit replacement when the original connector is damaged or burned. What it does:

• Provides a secure termination point for multiple wires so circuits can complete and controls receive power.
• Replaces corroded, loose, or burned terminals that cause intermittent power, no-heat or no-power issues.
• Maintains correct wiring alignment to prevent shorts or poor contact.
• Helps eliminate symptoms like a blank display, burners or elements not powering, or sporadic operation tied to a bad connection.

• Always disconnect power to the appliance (unplug or switch off breaker) before inspecting or replacing electrical parts.
• Verify wire locations and take a photo before removal to preserve proper wiring order.
• Replace only if terminals are visibly damaged, loose, or show signs of burning; secure all screws/nuts to factory tightness.

This metal angle flue guard protects and covers the flue opening on compatible gas ranges, helping direct exhaust and keeping nearby components shielded from heat. It restores the range's original flue trim and helps maintain safe operation. What it does:

• Replaces a bent, cracked or missing flue guard that no longer shields the flue opening
• Directs heat and combustion byproducts away from surrounding panels and components
• Helps reduce hot spots and contact with wiring or insulation near the flue area
• Restores proper fit and appearance of the cooktop/flue assembly

• One angle flue guard

• Turn off and disconnect power and gas supply before starting any repair
• Remove cooktop or access panels as required to reach the flue; retain original fasteners unless new ones are supplied
• Handle edges carefully; metal trim may be sharp