Pse25kyhfs Parts

Size: 8-32 t. Includes 12 screws.

Foam sleeve that insulates refrigerator tubing to reduce condensation. Replace when worn, cracked, or missing to restore padding and protection.

Protective cover assembly for your side-by-side refrigerator's RFID module with FCC compliance label. Replace if cracked, broken, or missing.

Decorative nameplate that mounts on the appliance exterior to display the manufacturer's emblem. Replace if original badge is damaged, faded, or missing.

Left-hand slide basket provides sliding support for refrigerator drawers. Replace if your original bracket is cracked, broken, or worn for smooth operation.

Replacement mounting screw for securing panels, trim, and internal components in appliances. Needed when original screws are stripped, lost, or damaged.

This orifice and fan motor assembly replaces the heater or combustion air fan and its mounted orifice to restore proper airflow and ignition performance in gas appliance units. It helps stabilize burner operation and supports reliable heating cycles. What it does:

• Moves combustion/vent air to maintain proper burner airflow and consistent flame behavior
• Positions and secures the gas orifice to ensure correct fuel delivery to the burner
• Helps reduce frequent ignition failure, weak flames, or uneven heating when failing
• Works as a direct-fit replacement when the original orifice and small blower motor are worn or damaged

• Turn off gas supply and power to the appliance before attempting service
• Replace only with the exact part number shown; follow the appliance manufacturer's disassembly steps
• Check gas connections and seals after installation for leaks; use a gas leak detector or soapy water test

Sheet metal screw secures refrigerator panels, trim, and brackets. Replace missing, stripped, or corroded screws to restore proper fit and assembly.

Molded duct assembly directs cold air from freezer to fresh-food section. Replace if cracked, broken, or damaged to restore proper airflow balance.

Fix a loose or missing water filter with this housing cover. Secures the filter in place for proper seal and reliable water flow. Simple snap-in install.

Upper freezer tower bracket secures the ice/tower assembly inside your refrigerator's freezer. Replace if cracked, broken, or missing to restore support.

Machine screw secures panels, brackets, and components in refrigerators. Replaces lost, stripped, or damaged 10-32 fasteners to restore stability.

10-32 x 5/16 machine-thread screw secures refrigerator panels, trim, and internal brackets. Replaces missing or damaged fasteners to prevent rattles.

Rubber grommet secures the base grille on your refrigerator. Replace if cracked, worn, or missing to restore a snug fit and reduce vibration or rattle.

This sound damper cushions the refrigerator compressor to reduce vibration and minimize noise for quieter operation. It helps protect the compressor from metal-on-metal contact and dampens normal operating sounds. What it does:

• Cushions compressor mounting to absorb vibration and reduce noise
• Prevents metal-on-metal contact that can cause rattling or buzzing
• Helps stabilize the compressor to reduce wear from vibration
• Commonly used when compressor noise, rattling, or increased vibration is noticed

• One sound damper

• Always disconnect power to the appliance before beginning any repair
• Access the compressor area (rear lower cabinet); remove any panels as needed
• Remove the old damper and press the replacement onto the compressor mounting foot until fully seated
• If mounting hardware is damaged or the compressor mount appears worn, replace mounting parts.