Pshss6rgxcdss Parts

This middle reflector assembly directs heat and light inside the appliance to help ensure even cooking and protect surrounding components. It replaces a damaged or missing middle reflector to restore proper internal reflectivity and airflow. What it does:

• Reflects heat/light away from the heating element to promote even cooking and prevent hotspots
• Shields internal wiring and components from direct heat exposure
• Helps maintain designed airflow patterns for efficient operation
• Replace if warped, cracked, burned, or missing to reduce risk of uneven cooking or component damage

• Disconnect power (and gas, if applicable) before servicing; allow the appliance to cool completely
• Handle carefully—edges may be sharp; wear gloves and eye protection
• Keep all original fasteners; verify alignment before tightening

This middle reflector assembly directs and focuses interior light for a clean, even appearance inside the appliance. It replaces a cracked, missing, or misaligned reflector to restore proper light distribution and finish. What it does:

• Reflects and redirects interior lamp output for improved visibility
• Covers and protects the light area from debris and accidental contact
• Restores finished appearance where a reflector is cracked, discolored, or missing
• Works with the appliance's lamp housing to maintain intended illumination pattern

• One middle reflector assembly

• Disconnect power before starting any work to avoid shock
• Remove shelves or trim as needed to access the reflector; handle carefully to avoid scratches
• Align and secure the reflector into the existing housing using original clips or fasteners
• If lamp or housing is damaged, inspect those components and replace as needed.

This insert plenum assembly directs airflow inside the appliance to support proper venting and component fit. It replaces a damaged or warped plenum to restore intended airflow paths and internal alignment. What it does:

• Channels and directs internal airflow for proper venting and temperature distribution
• Replaces cracked, warped, or damaged plenum that can disrupt airflow or cause rattling
• Helps reduce unusual noises or vibration caused by loose or broken plenum sections
• Ensures other components mount and seal correctly where the plenum provides support

• One insert plenum assembly

• Disconnect power (and gas, if applicable) before starting any repair
• Handle edges carefully; part may have sharp metal or plastic edges
• Basic hand tools typically required; follow the appliance service manual for disassembly/reassembly steps

This door gasket seals the refrigerator compartment to help maintain proper temperature and energy efficiency. It replaces a worn or damaged seal so cold air stays inside and warm, humid air stays out. What it does:

• Creates an airtight seal around the refrigerator door to reduce temperature fluctuations
• Helps prevent frost build-up and condensation by keeping warm air from entering
• Supports consistent cooling performance and helps reduce energy use
• Commonly replaced when the seal is cracked, torn, flattened, or no longer closes tightly

• Designed for direct replacement; fit by comparing part to the existing gasket before installation
• Clean the door flange and remove old gasket adhesive/residue for best seal
• Work slowly around corners to seat the gasket evenly; heat (hair dryer) may help soften stiffer gaskets for fitting
• Disconnect power if required by your model before performing any repairs and follow all safety instructions in your appliance manual

This adhesive-backed foam sealing strip provides a simple replacement to seal small gaps and cushion contact points on appliance doors and panels, helping reduce drafts, moisture intrusion, and rattling. What it does:

• Seals small gaps around doors, panels or assemblies to help limit air and moisture transfer and reduce condensation
• Cushions surfaces to minimize vibration and rattling noises
• Helps improve temperature retention by closing unintended openings
• Commonly replaced when foam is torn, compressed, detached, or causing drafts

• Verify the mounting surface is clean, dry and free of grease or old adhesive before applying
• Measure and trim the strip to fit; peel back adhesive liner and press firmly along the full length
• Avoid stretching the foam during installation for best seal and adhesion
• If adhesion is poor, remove residue and consider using a manufacturer-approved adhesive