Sgsxp365ts Parts

Replace a faulty gas cooktop manifold if burners won't ignite, flames are uneven, or gas flow is restricted. Moderate DIY repair with proper tools.

This retaining washer secures a control shaft or hub to keep components in place during operation, helping restore proper control movement and prevent parts from sliding off the shaft. Simple replacement when a worn or missing retainer causes loose knobs or shifting parts. What it does:

• Fits onto a control or drive shaft to hold a knob, hub or gear in position
• Prevents axial movement that can cause loose or slipping controls
• Commonly replaced when the original washer is bent, cracked, or lost
• Works with compatible Bosch control assemblies and hubs

• One retaining washer

• Recommended for users comfortable with basic appliance disassembly; unplug appliance before starting
• Remove the control knob or panel per model instructions to access the shaft
• Press the washer into place on the shaft until fully seated; verify proper fit and control operation

This replacement door gasket seals the dishwasher door to keep water inside the tub and help maintain wash performance. It restores a tight door seal to reduce leaks and prevent water from pooling around the appliance. What it does:

• Creates a watertight seal between the door and tub to stop leaks during cycles
• Helps prevent water from dripping onto floors and surrounding cabinetry
• Reduces steam and moisture escape that can cause odors or damage
• Restores proper door closure where worn or flattened seals allow seepage

• Disconnect power and water supply before attempting any service.
• Inspect surrounding door edges for damage and clean mounting surfaces before installing the new gasket.
• Press the gasket firmly into the door channel; some models require partial door disassembly.
• After installation, run a short cycle and check for leaks before returning the dishwasher to regular use.

Left mounting bracket for cooktop installation. Secures cooktop to counter or cabinet. Replace if bracket is bent, cracked, or missing for proper support.

Replacement mounting screw for cooktops and ranges. Secures panels, brackets, and components. Needed when original screw is missing, stripped, or damaged.

Stainless steel hex washer head screw for cooktop assembly. Replace missing, stripped, or damaged screws to secure components properly during repair.

This is a variable resistance control that regulates the heat output of your cooktop's heating elements. It allows you to adjust cooking temperatures from low to high by controlling the electrical current to the elements. Replace it when burner heat levels can't be adjusted properly, elements stay on high heat, or temperature control becomes erratic.

Fix uneven flames or gas flow issues with this burner orifice holder. Secures the orifice for proper gas distribution to your cooktop burner.

Gas pressure regulator for ranges and cooktops. Controls fuel flow to burners. Replace if leaking, cracked, or damaged to restore proper gas delivery.

Replaces a worn, cracked, or warped burner base at the left 'D' position. Provides stable, heat-resistant support for the burner assembly on your cooktop.

Connects the spark electrode to the ignition module on your cooktop. Replace if the wire is damaged, frayed, cracked, or has broken insulation.

Fix gas leaks or burners that won't ignite with this cooktop gas valve. Controls gas flow to burner assembly for safe ignition and consistent heat.