Sts30 Parts

White corner cap cover for side-by-side refrigerators. Replaces cracked, broken, or missing corner trim pieces. Restores clean appearance.

Wire harness that connects the control module in your refrigerator. Replace if wires are frayed, connectors are damaged, or harness is broken or missing.

Rear trim for refrigerator glass shelves. Installs along the back edge of shelf to secure and finish the glass. Replace if cracked, broken, or missing.

This self-adhesive foam strip seals gaps and cushions components to reduce drafts, noise, and moisture intrusion—helpful for restoring proper airflow and improving efficiency where foam padding or gap sealing has deteriorated. What it does:

• Provides a soft seal to close small gaps and prevent air leaks
• Cushions panels to reduce vibration and rattling noises
• Helps limit moisture and dust entry around seals and components
• Supports consistent temperature by reducing unwanted airflow

• Clean and dry the mounting surface before applying for best adhesion.
• Trim to length with scissors or a utility knife; press firmly to set adhesive.
• Avoid stretching the foam while applying; allow adhesive to set 24 hours for full bond.
• If near electrical components, disconnect power before working and avoid covering vents.

Plastic air separator that directs cold air through refrigerator ducts on the high side. Replace if cracked, broken, or damaged to restore proper airflow.

Compressor clicks on and off or won't start? This PTC start relay energizes the compressor start winding to restore consistent cooling. DIY-friendly repair.

Compressor won't start or kicks out after trying? This overload protector prevents motor damage. DIY-friendly repair, takes about 30 minutes to replace.

Channels cold air from the evaporator fan through the freezer compartment. Replace if cracked, broken, or missing to restore proper airflow seal.

Half-width crisper drawer for refrigerators with Hammer Head shelf design. Replaces cracked, broken, or missing produce bins in the fresh-food compartment.

Replace a cracked, chipped, or missing glass shelf in your refrigerator. Restores smooth storage surface to keep food organized and visible.

Replacement door shelf retainer bar for refrigerators. Secures bottles and jars in door bins. Replace if broken, cracked, or missing to restore door storage.

Left hand side. For right hand use WR17X10862

Secures water tubing or wiring to your refrigerator cabinet. Replace if missing or damaged to prevent vibration, rubbing, or leaks. Confirm fit.

Vinyl sleeve that fits over rods, tubes, or wires in your refrigerator. Replace if cracked, torn, or missing to protect contact points and reduce wear.

This rear glass shelf trim replaces the finished glass edge at the back of a refrigerator shelf, restoring a secure seat and clean appearance. It helps keep items from sliding off and reduces gaps where spills can drip. What it does:

• Provides the finished rear edge and support for a refrigerator glass shelf.
• Helps the shelf seat and lock into position; a broken or missing trim can prevent proper seating.
• Reduces food/items from shifting toward the cabinet rear and helps contain minor spills.
• Restores appearance when the original trim is cracked, chipped, or worn.

• Handle the glass trim carefully; wear cut-resistant gloves and eye protection during installation.
• Remove the shelf per the appliance's OEM instructions before replacing the trim, then refit the shelf and verify it seats properly.
• Inspect mounting clips or supports and replace if damaged to ensure a secure fit.

Secures trim and panels in your refrigerator. Replace when broken clips cause loose parts or rattling. Verify fit with your model number.