Tbx 18Zg Parts

This rubber tube grommet cushions and protects a refrigerator water/tubing passage, helping prevent chafing and leaks where a tube passes through the cabinet. It's a simple replacement to restore a secure seal. What it does

• Cushions tubing where it passes through sheet metal or a cabinet panel to reduce wear.
• Helps keep the water/tube routing sealed and stable to minimize rubbing and potential leaks.
• Commonly replaced when the original grommet is cracked, split, or missing.
• Small, inexpensive part that prevents damage to lines and reduces vibration noise.

• One rubber tube grommet.

• Disconnect power and shut off the water supply before beginning any repair.
• Access location varies by model; remove panels or liners as needed to reach the tube/pass-through.
• Replace the damaged grommet by sliding the tube through the grommet and seating the grommet into the cabinet hole.
• Inspect tubing for damage while installing; replace tubing if abrasion or leaks are found.

Replacement shelf trim for refrigerator and freezer compartments. Snaps onto shelf edges to provide a finished look and protect against chips or cracks.

This breaker strip is a direct-fit electrical connector used in the bottom freezer compartment to secure and route wiring. It replaces a worn or damaged strip to restore reliable electrical connections and reduce arcing risk. What it does:

• Re-establishes secure connections between freezer wiring harnesses and components
• Prevents loose wires from causing intermittent power, arcing, or blown fuses
• Helps maintain consistent electrical routing and component grounding in the bottom freezer area
• Commonly replaced when connectors are cracked, melted, or no longer hold terminals firmly

• Disconnect power to the appliance before starting any repair to avoid shock or damage
• Requires basic hand tools and access to the freezer bottom panel or kickplate
• Match connector orientation and fully seat terminals; do not force mismatched plugs
• Inspect adjacent wiring and terminals for heat or melt damage and replace as needed

This top breaker strip is a replacement trim piece that restores the correct seal and fit along the top edge of the refrigerator door or cabinet opening. It helps maintain proper door alignment and prevents rubbing or gaps. What it does:

• Replaces damaged or worn top trim that can cause gasket misalignment or door rubbing
• Restores a flush fit between the door and cabinet at the top edge
• Reduces air leaks caused by bent or broken trim interfering with the gasket
• Helps the door close smoothly by removing obstruction from a broken strip

• One top breaker strip

• Disconnect power to the appliance before servicing to avoid injury
• Remove any door trim or screws holding the old strip; lift out the old strip and snap or slide the new strip into place
• Retain all fasteners; some models use clips or screws—replace as needed

Replacement nameplate for refrigerators. Installs on exterior cabinet to display model information. Order if original plate is damaged, faded, or missing.