Wed74heawo Parts

This is a plastic rear cover that protects the user interface and control actuator assembly on the dryer's control panel. It shields the wiring and electronic components behind the control board from dust and damage. Replace this cover if it is cracked, broken, or missing, which can leave sensitive control wiring exposed.

Replacement mounting nut for dryer assembly. Secures components and panels in place. Order a new nut if yours is stripped, corroded, or missing.

Replacement mounting nut for dryers. Secures panels, brackets, and assemblies. Replace if stripped, missing, or corroded during repairs or maintenance.

Secures dryer drum components and prevents rattling. Replace if broken or missing to restore quiet operation. Verify fit with your model number.

Complete dryer door assembly that installs on the front of your appliance. Replace if your door is cracked, broken, or won't close properly anymore.

Dryer won't power on or trips breaker? This terminal block plug connects power to your dryer's electrical system. Common fix for power issues.

This is a metal flange bracket that secures the heater housing assembly inside the dryer. It holds the heater box in the proper position to ensure safe and efficient heat distribution during drying cycles. Replace this bracket if it is bent, corroded, or broken, which can cause the heater housing to shift and lead to overheating or unusual noises.

This cable tie secures wiring and the power cord to the appliance chassis to help prevent chafing, pinching, or loose connections. Simple, low-cost part that restores proper wire routing and strain relief. What it does

• Holds wiring and harnesses in place to prevent rubbing against sharp edges
• Helps reduce risk of intermittent power or connector strain caused by loose wires
• Keeps harnesses routed for correct clearance and component access
• Useful during repairs to restore original wire routing and strain relief

• One cable tie (wire harness retainer)

• Safety first: disconnect the appliance from power before inspecting or replacing wiring components
• Remove the damaged or existing retainer and route harnesses to match original OEM routing before installing the new tie
• Trim excess tie tail; do not overtighten—secure, but avoid crushing wires
• Replace any tie that's melted, cracked, or otherwise damaged rather than reusing it

Replace your cracked or missing dryer drum baffle to restore proper tumbling action. This lifter bar attaches inside the drum to lift and separate clothes.

Replacement mounting screw for dryer assembly. Used to secure internal components and panels. Order a new screw if original is stripped, lost, or damaged.

Dryer seal that prevents air leaks and maintains proper airflow. Replace if you notice excessive lint buildup or reduced drying efficiency. Verify fit with your model number before ordering.

Fix a dryer that won't start, stops mid-cycle, or shows error codes with this electronic control board. Moderate difficulty repair typically completed in 1 hour.