Weg515sofbo Parts

Replaces the left inner door liner on your range. Install when the original liner is cracked, stained, or damaged to restore a clean door interior surface.

This factory screw secures panels, brackets, or trim within your appliance. Replacing a missing or stripped fastener restores a tight fit, reduces vibration and rattles, and helps keep components aligned for reliable, long-term performance.

• Fastens panels, brackets, or trim to the appliance cabinet/frame
• Replaces damaged, rusted, or missing hardware
• Helps eliminate vibration noises, gaps, and loose-fitting parts
• Supports proper alignment of adjoining components

• Disconnect power; turn off gas/water supplies where applicable.
• Match to the original screw from your model's parts diagram before installation.
• Start threads by hand to avoid cross-threading; use the correct driver bit for the head.
• Tighten snugly—do not overtighten to prevent stripping threads or cracking plastic bosses.

Replace worn range drawer glides to restore smooth sliding and eliminate sticking or rattling. Supports proper drawer alignment and movement. Confirm fit.

Black control console panel for electric and gas ranges. Mounts at the front of the range. Replace if cracked, broken, or buttons are worn or missing.

Replacement mounting screw for securing panels, brackets, and internal components. Needed when original screws are stripped, missing, or damaged during repair.

This spark module generates the electrical pulses needed to ignite gas at the burners on a gas range or cooktop. It receives a signal when a burner knob is turned and sends voltage to the spark electrodes to create ignition. Replace this module if one or more burners fail to spark, spark continuously, or only click without producing a flame.

Uneven flames or poor heat on your smallest burner? This auxiliary flame spreader cap restores even heat distribution. Simple DIY swap in minutes.

Replace a cracked or damaged burner head causing uneven flames or poor ignition. This metal component distributes gas for proper flame and heat output.

Fix uneven baking and hot spots in your gas oven. This flame spreader restores proper flame distribution for uniform heating and better baking results.

Front panel that covers your range drawer, providing a finished look. Replace if cracked, damaged, or worn to restore your kitchen's appearance.

Black lower door trim for electric range doors. Restores finished edge and covers seam. Replace when original is cracked, chipped, or missing.

Black push rivet for ranges. Secures panels and components inside your range. Replace if cracked, broken, or missing. Two-piece design presses into hole.

Restores the finished edge of your range fascia. Replace when trim is dented, scratched, or missing to seal control openings. Confirm fit with model.

Supports and guides your range drawer for smooth opening and closing. Replace when drawer sticks, drags, or derails. Verify fit with your model number.

This is a metal anti-tip bracket that anchors the range to the floor or wall to prevent it from tipping forward when weight is applied to an open oven door. It is a critical safety device required by installation codes. Replace this bracket if it is missing, bent, or damaged, or if the range rocks or shifts when the oven door is opened.

Replace a broken or missing door switch actuator rod on your range. This small rod engages the door switch to detect open/closed positions and control the interior light.