Wf3cb Water Filter Parts

My washer began to emit a roaring noise, especially during the spin cycle. After a little research I determined that the likely culprit was seal and bearing failure plaguing front-load washing machines. I disassembled my Samsung WF306LAW/XAA in order to gain access to the three bearings. Identifying the three distinct bearing sizes from the failed parts, I was able to source a seal+bearings kit from a few Internet suppliers. After cleaning off the flange shaft assembly I could tell by the... Read more

Since the DC61-01558A was discontinued, I came across DC97-10417A during my online research. They appeared to be exactly the same, so......I decided to give it a try. After ensuring the water and electricity supplies are shut off, I remove the two screws at the rear of washer, opened the lid to access the water guide. It was a perfect match. I used a Philips screwdriver, a needle nose plier to complete the task. Very easy to do, just can't believe a plastic part costs over $100.00! Read more

Finally found the correct part on your site after ordering it on another site and recieving the part that the door snaps onto. It was an easy fix just plastic parts that snap together. Thank you! Read more

Replaced the Spider Arm with new ordered part as well as replaced the Door Boot Seal. With unit apart it took 3 hours to reassemble the washer. Works great now with NO leaks! Read more

Very easily! the entire front of the drawer pops off, and the replacement clicks into place. took about 5 minutes and one little tool to push the "pins" out to release the drawer front. Read more

• Noisy
• won't spin

Ordered part for rear tube for the Samsung Washer. Totally disassembled my washing machine which is a Samsung WF409ANW/XAA. Rear tube leaked near the train tube. Look like something caused damage to the corner of the plastic where the drain tube connects. This is a poorly made machine. Had previously replaced the spindle arm which was severely corroded. Wrote Samsung on this regarding a design flaw. Still waiting on a reply which will never happen since my letter probably needs to be... Read more

Pulled top off (4 black screws on back of machine, top right and left corners). Slide lid straight back. Pcb was mounted to back wall of machine. Simple switch out, took a couple of minutes, a part that was less than $40.00 and I was doing laundry again. Beats spending another $800-$1000 on a new machine! Read more

Computer board was the problem too bad I went thru buying a drain pump first should have just purchased the computer board . but WOOHOO it is working and this site was the cheapest for the part . easy fix took no time at all to replace . Read more

Ordered another one Read more

Maytag neptune that I purchessed in 2005 would sometimes beep and show error code.Noted that this would happen when it attemped to enter the high speed spin cycle,from info that I got from BLOG someone sugested most proble cause MOTOR. This makes sense to me.Hope he was right,so far so good. Read more