Wfmc2201uc Parts

This hose inlet is the water inlet connection that directs incoming water into the appliance, restoring a secure supply path and helping prevent leaks at the entry point. What it does

• Provides the sealed connection point for the incoming water supply hose.
• Routes water into the appliance's fill system so cycles can start and run properly.
• Helps prevent leaks where the external supply hose attaches.
• Commonly replaced when water won't enter, the connection leaks, or the inlet is damaged.

• One hose inlet connection.

• Turn off the water supply and disconnect power before replacing.
• Inspect existing seals or gaskets; replace if cracked or worn.
• Tighten connections to hand-firm plus a quarter turn; avoid overtightening.
• After installation, restore water and power and check thoroughly for leaks during a fill cycle.

Mounting bracket for washer installations. Secures and stabilizes washer components. Replace if bent, cracked, or broken to restore proper support.

The Cold Water Inlet Hose is an OEM replacement part for Bosch washing machines. It serves as a flexible supply line that delivers cold water from an external plumbing source directly to the washer. This hose plays an important role in providing a balanced mix of hot and cold water flow into the unit.

Symptoms of a bad cold water inlet hose include:

• Fluctuations in water temperature during cycles  
• Issues with certain temperature settings like warm or cold not operating properly
• Visible cracking, kinking, or leaking along the hose body
• No water flow or pressure at the cold supply 

Causes of a failed cold water inlet hose can be mineral deposits clogging the line, natural wear and tear over time, or physical damage from crushing or abrasive surfaces compromising its integrity.

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore washing machine models.

Directs water from your home supply into the washer. Replace if cracked or leaking to restore proper fill and prevent water damage. Confirm fit with your model.

Replaces the outer door panel on your washer. Install when dented, scratched, or corroded to restore appearance and ensure proper door closure and seal.

Front drum motor mounting bushing for washers. Supports the drum shaft for smooth rotation. Replace if worn, cracked, or causing misalignment issues.

This replacement hose connects the dishwasher drain/sump to the drain system, restoring proper water removal and preventing leaks or standing water. It's a direct-fit service part when the original hose is cracked or clogged. What it does

• Carries waste water from the dishwasher sump to the household drain or disposal
• Restores proper draining when a split, collapsed, or clogged hose causes standing water
• Helps stop leaks and puddling that can occur from worn or damaged hose sections
• Maintains correct flow to prevent dishwasher error codes related to drainage

• Turn off power and water supply to the appliance before starting any repair
• Inspect hose routing and clamps; replace any damaged clamps or retainers for a secure seal
• Ensure hose connections are tight and routed without kinks to allow proper drainage

This is a mounting holder used inside a washing machine to secure internal components in place. It provides structural support and helps maintain proper alignment during operation. Replace this holder if it is cracked, worn, or broken, which can cause excessive vibration, unusual noises, or misalignment of internal parts.

Fix a washer that won't heat water properly or stops mid-cycle with error codes. This temperature sensor monitors and regulates water temperature accurately.

Fix washer water level issues or won't fill correctly with a new pressure chamber. This part regulates water sensing for proper fill cycles.