Wlsh2000g3ww Parts

I had to replace the 3 terminals and try to put them in the new terminal receptacle. I replaced the lid switch because I broke the old one trying to diagnose the problem. I found the helpful video on this site after I had already started. Read more

Searched online what could be causing the problem after mopping water for a good 30 minutes. Chatted online with a specialist at Appliance Parts Pros. After trying several things by process of elimination I was advised that the problem was more than likely the water level switch. Ordered the part. It arrived in 2 days. Installed the switch which took less than 10 minutes and now my machine is as good as new. Thank You Appliance Pros. Read more

AppliancePartsPros had the problem areas for my washer model. I clicked on the appropriate one and viewed the comments, solutions and install videos. The videos are great! Not knowing which part might be bad, I purchased the recommend solution parts. The first two solved the problem and I returned the unneeded third part through the simple returns process. The returns process did ask a question about the part model and serial number which was not on the box and would not let me go forward... Read more

Ordered water inlet solinoid valve and water temperature probe sensor. Items arrived in a few days. Appliance Parts Pros on-line video was extremely helpful for replacing inlet valve. It only took 20 minutes. Recommend replacing temp. sensor probe while old valve is out before mounting new valve. Only 2 screws-Easy. Entire job took about an hour start to finish. Saved at least $150 doing it myself over repairman and saved $750 over replacing the washer. Happy wife, happy life! Read more

The washer would not fill at all, with either hot or cold selected, but the agitator would start moving as if it were in fact full. Found that the Water Level (Pressure ) Switch's contact read open (infinite resistance) even with no water in the tub. Replaced it with the new switch and everything was golden once again. Good, quick repair, high quality part (physically identical to the original), fast shipping, excellent price. What's not to like? Read more

Replaced both switch and knob. BE SURE TO UNPLUG! Remove knob by removing clip on timer shaft between knob and control panel with needle nose pliers . Remove back of control panel (three 1/4" head screws), push plastic control panel forward enough to get access, unclip wiring harness, remove one 1/4" head screw holding timer, slightly twist timer to release tabs, and remove. Assembly is reverse of above. Really easy, takes more time to get washer out and back in place than it does to replace... Read more

• Will not stop filling with water

We had two problems at the same time. The washer was occasionally overflowing especially on super loads, and also leaking out the bottom, which got worse really fast. The overflow problem we have had before when the pressure switch hose became plugged with gunk, but cleaning the hose didn' fix it this time. The leak could be seen just above the trans. housing at the drum, so we diagnosed a bad seal. Knowing that the bearing would have to be running with water in it we also ordered the bearing... Read more

Water would continue to fill the machine even when the washer was unplugged. Had it stopped filling when the electrical was disconnected, the problem might have pointed to the pressure switch that determines water level but that was not the case. So, the valve was ordered and it was a very simple job to just replace the old part. Read more