Wm343hs Parts

Spider arm assembly for washers. Connects drum to shaft. Replace if cracked, corroded, or broken. Essential structural component for drum support.

Control knob assembly for washer control panels. Replace a cracked, broken, or missing knob that no longer grips or turns properly during cycle selection.

Outlet duct housing for front-load washers. Connects drain pump to exterior outlet. Replace if cracked, broken, or leaking at connection points.

Joins washer plumbing lines to create a watertight seal. Replace your cracked, damaged, or leaking connector to restore secure water routing between hoses.

Inlet hose for washers. Connects water supply to machine. Replace if cracked, leaking, kinked, or worn. Essential for proper water flow to drum.

Door boot seal bellows for front-load washers. Creates watertight seal between drum and door. Replace if torn, cracked, moldy, or leaking during wash cycles.

This rear cover is the exterior cabinet panel that protects the appliance's internal components and helps maintain proper airflow. It restores a finished back surface and prevents debris or pets from contacting working parts. What it does:

• Protects internal parts from dust, spills and physical damage
• Helps direct airflow and maintain proper ventilation paths
• Replaces cracked, warped or missing back panel that can cause rattles or expose components
• Reduces risk of foreign objects entering the appliance and interfering with operation

• One rear cover panel

• Disconnect power and any fuel lines before beginning repair
• Remove existing access panels and fasteners; retain hardware if reusing
• Handle edges carefully—metal panels can be sharp

This balance weight stabilizes the washer drum to reduce vibration and keep the washer steady during spin cycles. Replacing a worn or damaged weight restores smoother operation and reduces shaking and noise. What it does:

• Adds mass to the washer frame/drum assembly so the tub stays balanced during spin
• Helps prevent excessive vibration, banging, and movement during high-speed spins
• Reduces noise caused by an unbalanced load or damaged weight
• Supports proper drum alignment to avoid premature wear on bearings and suspension parts

• One balance weight

• Always unplug the washer before starting any repair to avoid electrical shock
• Support the drum/tub when removing or installing the weight to prevent component damage
• Reuse or replace any mounting hardware only if explicitly specified by the manufacturer
• If vibration persists after replacement, inspect suspension, shock absorbers, and mounting points