Wrt138fzdm Parts

Refrigerator not cooling or freezer icing up? A faulty compressor may be the cause. This part is the heart of your cooling system, requiring expertise.

Secures the roller pin in refrigerator drawer and track assemblies. Replace if missing, bent, or broken to prevent bins from tilting, binding, or dropping.

Replacement mounting screw for refrigerator panels, brackets, and trim. Restores secure fit when original screw is stripped, missing, or damaged.

This orifice is a small precision component used in the refrigerator's cooling system to regulate refrigerant or gas flow. It is typically located near the evaporator or cooling circuit and helps control the rate at which refrigerant enters the evaporator coil. Replace this part if the refrigerator or freezer section is not cooling properly, frost patterns are uneven, or a technician has identified a restricted or damaged orifice during diagnosis.

Touch-up paint for appliances. Covers chips, scratches, and worn areas on range tops, refrigerators, and other appliances. Includes brush applicator.

Adjustable leveling leg that threads into the refrigerator base to stabilize and level your appliance. Replace if cracked, stripped, or missing.

Replacement hinge pin that acts as the pivot point for your refrigerator door. Install when the original pin is worn, broken, or missing.

A decorative plastic piece that covers the end of refrigerator door handles where they attach to the door surface. Replace if the cover is cracked, discolored, missing, or loose, which can expose mounting screws and create an unfinished appearance.

This is the fan blade that attaches to the condenser fan motor, typically located near the bottom rear of the refrigerator. It draws air across the condenser coils to dissipate heat and keep the refrigerator running efficiently. Replace this blade if it is cracked, warped, or broken, which can cause loud noises, reduced cooling performance, or the compressor overheating.

Fix uneven cooling or freezing in fresh food section with a new air duct. Channels air from freezer to refrigerator compartment. Basic DIY repair.

Replace a cracked, broken, or missing hinge cover on your refrigerator. Snaps over the hinge assembly to conceal hardware and restore a clean finish.

This replacement screw secures panels, brackets, and other components in your appliance so they stay tight and properly aligned. Use it to replace missing, stripped, or rusted hardware and eliminate looseness, rattles, or gaps.

• Fastens parts to the cabinet/frame to maintain structural integrity
• Helps keep panels and assemblies aligned to reduce vibration and noise
• Replaces missing, damaged, or corroded screws during service
• Common fix for loose panels or components that no longer hold securely

• Disconnect power and shut off water or gas before servicing
• Match length and thread to the original screw for proper fit
• Hand-start threads to avoid cross-threading; tighten only until snug—do not overtighten
• Tighten them evenly to ensure proper alignment

Size: 8-18 x 1/2 inch.

Color: Black. Size: 12 oz. Acrylic appliance aerosol can spray paint.

Screw: 8-16 x 3/8 inch.

Replace worn or missing fastener washers in your refrigerator to restore secure fits and reduce vibration. Distributes load evenly under bolts. Verify fit with your model number before ordering.