Wrt318fzdm Parts

Color: Grey

Protective seal grommet for hoses, tubes, or wires passing through refrigerator cabinet. Replaces cracked, worn, or missing grommets to prevent leaks.

This is the fan blade that attaches to the condenser fan motor, typically located near the bottom rear of the refrigerator. It draws air across the condenser coils to dissipate heat and keep the refrigerator running efficiently. Replace this blade if it is cracked, warped, or broken, which can cause loud noises, reduced cooling performance, or the compressor overheating.

Grey end cap that covers and protects the end of your refrigerator door handle. Replace if cracked, broken, or missing due to wear or damage.

Replacement mounting screw for refrigerator panels, brackets, and trim. Restores secure fit when original screw is stripped, missing, or damaged.

This orifice is a small precision component used in the refrigerator's cooling system to regulate refrigerant or gas flow. It is typically located near the evaporator or cooling circuit and helps control the rate at which refrigerant enters the evaporator coil. Replace this part if the refrigerator or freezer section is not cooling properly, frost patterns are uneven, or a technician has identified a restricted or damaged orifice during diagnosis.

The Door Trim is an OEM part for Whirlpool refrigerators. It acts as a trim and edging along refrigerator shelves located on the door. The shelf trim allows items placed on shelves to be properly contained and prevent accidental falls.

Causes of a bad shelf trim include cracks, chips or peeling of the trim material from years of use and stresses from items placed on shelves.

Symptoms of a bad shelf trim include:

• Gaps appearing around shelf edges allowing smaller items to fall through
• Loose or uneven fit of trim that distorts the shelf structure
• Visible fasteners or unfinished shelf edges

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

Replacement hinge pin that acts as the pivot point for your refrigerator door. Install when the original pin is worn, broken, or missing.

Secures the roller pin in refrigerator drawer and track assemblies. Replace if missing, bent, or broken to prevent bins from tilting, binding, or dropping.

Adjustable leveling leg that threads into the refrigerator base to stabilize and level your appliance. Replace if cracked, stripped, or missing.

Fix uneven cooling or freezing in fresh food section with a new air duct. Channels air from freezer to refrigerator compartment. Basic DIY repair.

Replacement light bulb restores bright interior illumination. Replace when bulb burns out or flickers. Verify compatibility with your model number.

Replace a cracked, broken, or missing hinge cover on your refrigerator. Snaps over the hinge assembly to conceal hardware and restore a clean finish.

This replacement screw secures panels, brackets, and other components in your appliance so they stay tight and properly aligned. Use it to replace missing, stripped, or rusted hardware and eliminate looseness, rattles, or gaps.

• Fastens parts to the cabinet/frame to maintain structural integrity
• Helps keep panels and assemblies aligned to reduce vibration and noise
• Replaces missing, damaged, or corroded screws during service
• Common fix for loose panels or components that no longer hold securely

• Disconnect power and shut off water or gas before servicing
• Match length and thread to the original screw for proper fit
• Hand-start threads to avoid cross-threading; tighten only until snug—do not overtighten
• Tighten them evenly to ensure proper alignment

A decorative plastic piece that covers the end of refrigerator door handles where they attach to the door surface. Replace if the cover is cracked, discolored, missing, or loose, which can expose mounting screws and create an unfinished appearance.

Screw: 8-16 x 3/8 inch.