Wrx735sdhv Parts

This defrost heater assembly mounts near the evaporator coils inside the freezer section of a refrigerator. It generates heat during the defrost cycle to melt frost and ice buildup on the evaporator, allowing the cooling system to operate efficiently. Replace this part if you notice excessive frost buildup in the freezer, the refrigerator is not cooling properly, or the defrost cycle is no longer functioning.

Rubber mounting grommet cushions components and reduces vibration in refrigerators. Replaces worn, cracked, or missing grommets for secure positioning.

Secures internal panels and components in your refrigerator. Replaces worn, broken, or missing brackets to restore proper alignment and support.

This evaporator clip secures the refrigerator evaporator assembly and related components so the cooling system stays aligned and vibration-free. It helps maintain proper airflow and prevents rubbing or loose parts. What it does:

• Holds the evaporator coil/assembly or associated covers in place
• Prevents vibration, noise, and contact between the coil and cabinet parts
• Helps maintain consistent airflow for reliable cooling performance
• Commonly linked to rattling, buzzing, or loose parts around the freezer evaporator

• Disconnect power before servicing the appliance
• Handle evaporator and surrounding fins carefully; they are sharp and fragile
• Verify clip orientation against the OEM diagram before fastening

Secures and seals the water filter in its housing. Replace if cracked, broken, or missing to restore a proper fit after filter changes.

Drive gear for bottom-mount refrigerators. Transmits motor motion to operate mechanisms. Replace when gear teeth are worn, stripped, or broken.

Replace your refrigerator door closer to restore smooth, controlled closing and prevent door slamming. Maintains proper alignment for a reliable seal.

Fix a refrigerator door that won't close or latch properly. This door shut arm guides and secures the door for reliable closing. Direct fit replacement part.

This insul-sound deadening pad reduces vibration and noise by dampening panels and components in laundry and kitchen appliances. It's a small adhesive-backed sound/isolation pad used where noise or rattles transfer through metal surfaces. What it does

• Dampens rattles and reduces structure-borne noise from panels, cabinets and housings.
• Helps isolate vibrating components from appliance chassis to lower perceived sound.
• Commonly applied behind control panels, cabinet walls or on motor mounts to cut vibration transmission.
• Useful when worn, detached or hardened factory pads allow increased noise.

• One insul-sound deadening pad

• Disconnect power before servicing an appliance to avoid shock or injury.
• Clean and dry mounting surface; press pad firmly to ensure adhesive contact.
• Replace only in the original location; do not cover vents or moving parts.
• If adhesive is weak, use OEM-approved adhesive; avoid solvents that may damage finishes.

TheWire Harness is an OEM part for Whirlpool refrigerators. It carries power from the wall outlet to the various electrical components inside the refrigerator compartment and freezer. The harness includes all necessary insulated wiring and connectors required to safely deliver power throughout the appliance.

Causes of failure can be normal wear and tear over time from repeated connecting/disconnecting from the wall outlet. Rodents or small animals may also cause damage by gnawing on wires. Hardware failures like loose connections or short circuits could also negatively impact performance.

Symptoms of a bad power cord wire harness include:

• No power to refrigerator or freezer
• Intermittent power issues
• Tripped breaker after plugging fridge back in
• Frayed, cracked, or damaged insulation on wires
• Loose, disconnected, or corroded connectors

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.