Wsf26c3exfo1 Parts

Decorative escutcheon trim for refrigerator dispenser panel. Replaces cracked, discolored, or missing trim pieces on side-by-side models.

Replace your refrigerator's ice dispenser flipper door if cracked, broken, or missing. Installs in the dispenser chute to control ice flow.

Replacement clip for refrigerators and freezers. Secures shelves, bins, or internal components. Order a new clip if yours is broken, cracked, or missing.

This ice container (ice bin) stores ice made by the icemaker and interfaces with the dispenser drive to deliver cubes or crushed ice. Replacing a cracked or worn bin restores dependable ice storage and dispensing performance.

• Holds finished ice and guides it to the dispenser chute
• Engages the drive to move ice out when the dispenser is activated
• A cracked, warped, or stripped bin can cause no/slow ice dispensing or jams
• Damage may prevent the bin from seating fully or allow ice to spill/frost up

• Unplug the refrigerator or switch off power at the breaker before servicing
• Remove the old bin, clear any clumped ice, and seat the new bin so the rear drive interface engages—do not force
• Restore power and allow the icemaker to produce ice before testing dispensing

This is a rear panel cover that attaches to the back of the refrigerator, enclosing and protecting internal components. It helps maintain proper airflow and keeps dust and debris away from mechanical and electrical parts. Replace this cover if it is cracked, warped, or missing, which can lead to reduced cooling efficiency or excessive noise.

Secures panels, brackets, and internal components in your refrigerator. Replace missing, stripped, or corroded screws to restore tight assembly fit.

Replace worn refrigerator door hinge cam bushings to restore smooth door swing and proper alignment. Fixes doors that don't close fully or seal correctly.

Lower front grille that covers the base opening of your refrigerator. Replace if cracked, broken, or missing to restore a finished look.

Molded plastic drawer for freezer compartment. Replace if cracked, warped, or broken to restore smooth sliding and keep frozen items organized.

This thermostat retainer clip secures the defrost thermostat to the evaporator tubing in your refrigerator or freezer, maintaining firm contact for accurate temperature sensing and dependable defrost operation.

• Holds the thermostat firmly against the evaporator line for proper temperature feedback
• Helps prevent a loose or dangling thermostat that contribute to frost buildup and poor defrost performance
• Restores correct mounting when the original clip is cracked, bent, or missing
• Common signs include a broken clip or a thermostat not attached to the coil

• Disconnect power to the appliance before servicing; wear cut-resistant gloves
• Access the evaporator compartment; remove accumulated frost/ice as needed without prying on coil fins
• Position the thermostat body flat against the tubing and snap the retainer over it, avoiding pinched wires or damaged fins
• Confirm a secure fit and proper wire routing before reassembling and restoring power

Main wire harness that routes power between the control board and components. Replace if wiring is damaged, burned, or connector clips are broken.

White molded trim pan that restores the lower exterior appearance of your refrigerator. Replaces cracked, warped, or discolored trim pieces.